DeLonghi HFS50D15 Manual De Instrucciones página 5

of the heater and keep them away from the
sides and rear.
- Do not run cord under carpeting. Do not
cover cord with throw rugs, runners, or the
like. Arrange cord away from traffic area and
where it will not be tripped over. Do not route
cord under furniture or appliances.
- To prevent a possible fire, do not block air in-
takes or exhaust in any manner. Do not use on
soft surfaces,like a bed, where openings may
become blocked.
- Do not place the heater near a bed because
objects such as pillows or blankets can fall off
the bed and be ignited by the heater.
- Do not use the appliance to dry laundry, and
do not obstruct the air intake and outlet
grilles (danger of overheating).
- Do not operate the appliance in contact with
walls, furniture, curtains, etc.
- A heater has hot or arcing or sparking parts
inside. Do not use it in areas where gasoline,
paint, or flammable liquids are used or stored.
- It is normal for the heater's plug and cord
to feel warm to the touch. A plug or cord
which becomes hot to the touch or becomes
distorted in shape may be a result of a worn
electrical outlet. Worn outlets or receptacles
should be replaced prior to further use of the
heater. Plugging heater into a worn outlet /
receptacle/ may result in overheating of the
power cord or fire.
- If the supply cord is damage, it must be re-
placed by the manufacturer, its service agent
or similarly qualified person in order to avoid
a hazard.
- Do not wrap the cord around the appliance
immediately after use.
- WARNING: Do not cover the appliance while
it is functioning in order to avoid overheating
which may cause risk of fire.
Please note:
This symbol indicates recommendations and important
information for the user.
- If your appliance is equipped with a poly-
thene tape used as carry handle, remove it
before connecting appliance to the outlet.
- Always use the appliance stand alone on the
floor and in an upright position.
- To disconnect heater, turn controls to off, then
remove plug from outlet.
- Connect to properly polarized outlets only.
- This heater is not intended for use with an
extension cord or outlet strip. Plug the cord
directly into an appropriate wall receptable.
- Check that neither the appliance nor the
power cable have been damaged in any way
during transportation.
- Do not use the appliance in rooms with a floor
area of less than 43 square feet (4mq).
- Make sure that no pieces of polystyrene or
other packaging material have been left on
the appliance. It may be necessary to pass
over the appliance with a vacuum cleaner.
- When switching on the appliance for the first
time, allow it to run at full power for at least
two hours to get rid of the unpleasant smell.
Make sure that the room in which the appliance
is located is well ventilated during this opera-
tion. It is normal for the appliance to emit small
cracking sounds when you turn it on.
- Do not open the appliance. No user-service-
able parts inside.
- Before storing the appliance, check it is com-
pletely off and the cable is unplugged. At this
point wrap the cord around the base. Do not
store in a dusty room. The room temperature
should be between 32-86°F (0-30°C). Do not
load anything above it.
- Heaters draw more current than small appli-
ances, overheating of the outlet may occur
even if it has not occured with the use of other
appliances.
SAVE THESE
INSTRUCTIONS
THIS PRODUCT IS FOR HOUSEHOLD USE
ONLY
5