Mountain Buggy Carrycot Manual De Instrucciones página 8

›››
PLEASE FOLLOW THESE INSTRUCTIONS IF YOU
ARE FITTING:
Fitting the Snap Locks to the Carrycot
Preparation
You will need to have all components on the parts list
shown to fi t Carrycot to your stroller.
Have a look at sides of Carrycot. There are three holes
on each side of Carrycot to allow snap locks to be fi tted.
Confi guration varies depending on the Mountain Buggy
model you have.
• Two snap locks are fi tted to each side of Carrycot.
The unused hole can be fi tted with the spare screw
and cover button.
How to fi t the Snap Locks
1. Place one snap lock over hole A. Make sure it is
aligned correctly with the hole in Carrycot.
2. Using Allen key, rotate screw in snap lock in
clockwise direction until screw is tight. Snap lock
will still be able to rotate but is fi rmly attached.
3. Connect second snap lock according to model
directions below.
4. Repeat on other side.
For Urban (Jungle) models
5. Fit second snap lock to position B.
6. Fit small screw and cover button to hole C.
For Terrain Models
5. Fit second snap lock to position C.
6. Fit small screw and cover button to hole B.
Confi guration 1 Instructions
a: a Single Carrycot to a Single Stroller
b: a Twin Carrycot to a Double Stroller
PARTS LIST
Carrycot
4 x snap locks
Allen key
2 x screws
2 x cover buttons
A
URBAN
A
B
TERRAIN
A
B
C
C