HID iCLASS SE Biometric Guia De Instalacion página 2

iCLASS SE® Biometric/
iCLASS SE Display Reader
1
Mounting
ATTENTION
Observe precautions for handling ELECTROSTATIC SENSITIVE DEVICES
Reverse Configuration
Rotating the backplate 180° allows for placing the LCD display on left and the reader on right.
See PLT-02969 - Alternate Reader Assembly for instructions, before proceeding to Step 2: Wiring.
Scan the QR Code or visit
2
Wiring
Beeper GPIO1
GRN LED GP102
GND OC/TMPR
+VDC DATA1/CLK
DRAIN DATA2/DATA
RED GPIO3
HOLD GPIO4
P1
P2
Terminal Reader
(Terminal block and
module position varies)
All manuals and user guides at all-guides.com
RKL40, RPKL40, RKLB40
SRD MODEL: RKCL40E, RPKCL40E, RKCLB40E
Junction box
not included
Install gasket
Wall backplate
www.hidglobal.com/PLT-02969
PIGTAIL TERMINAL
Yellow P1-1
Orange P1-2
Black P1-3
Red P1-4
Drain P1-5
Brown P1-6
Blue P1-7
Red/Green P2-7
Tan P2-6
Violet P2-5
White P2-4
Green P2-3
Pink P2-2
Gray P2-1
Mounting holes for US double-gang electrical boxes.
DESCRIPTION
Beeper Input
LED Input (GRN)
Ground (RTN)
+VDC
Unused
LED Input (RED)
Hold Input
GPIO1/OSDP (RS485-FDX/HDX-A)
GPIO2/OSDP (RS485-FDX/HDX-B)
*Open Collector Output / Tamper
**Wiegand Data 1 / Clock
**Wiegand Data 0 / Data
GPIO3 (RS485-FDX-Z)
GPIO4 (RS485-FDX-Y)
2
PLT-03331, Rev. A.2
Notes
ƒ Previous iCLASS readers had
ƒ
reversed RS-485 wiring (P2-7 &
P2-6 - A & B). When upgrading
to an iCLASS SE reader, ensure
proper connections as defined
below.
ƒ It is possible to reuse existing
ƒ
Wiegand wiring for OSDP,
however, using simple stranded
cable typical of Wiegand
access control readers is
usually not meeting the RS485
twisted pair recommendations.
ƒ For OSDP cable lengths
ƒ
greater than 200ft. (61M) or
EMF interference, install 120Ω
+/- 2Ω resistor across RS-485
termination ends.
ƒ Wiring the reader incorrectly
ƒ
may permanently damage the
reader.