HID iCLASS SE RKL40 Guía De Instalación Rápida

I N STAL L ATI ON G UI DE
iCLASS SE® Biometric/
iCLASS SE Display Reader
RKL40, RPKL40, RKLB40
SRD MODEL: RKCL40E , RPKCL40E, RKCLB40E
Alternate Reader Assembly
The following steps reconfigure the reader assembly to
position the LCD Display component on the left side
of the assembly.
1. Disassemble the Reader.
• Remove the Reader from the backplate.
• Carefully unplug the ribbon cable from the module in
the back of the Reader. Caution: Do not pull on the
ribbon cable as this may damage the connection to
the connector.
• Remove the LCD Display from the backplate.
• Gently pull the ribbon cable through the backplate.
2. Reassemble with the LCD Display on the left side of the assembly.
• Rotate the backplate so that the large cutout for the power cable is on the right
• Gently route the ribbon cable back through the backplate slots, as shown below
• Plug the ribbon cable back into the module (back of Reader) and ensure module is fully
seated into the reader
• Attach the LCD Display to the backplate (this must be installed first, as the Reader will fit
slightly over the LCD Display)
• Attach the Reader to the backplate (power cable must be threaded through the large
square cutout on the backplate)
h id g l o b a l.co m
Standard Configuration
Reader
Reader
LCD Display
An ASSA ABLOY Group brand
Alternate Configuration
LCD Display
LCD Display
Ribbon Cable
Reader Backplate
Ribbon Cable
Reader Backplate
Reader
PLT-02969 Rev. A.2
LCD Display
Reader