Wonder workshop Guia Del Usuario página 4

Charging
• Use the supplied USB cable to charge your robots under adult supervision.
• Power source should be regularly examined for damage to the cord, plug, enclosure and other parts, and in the event of
such damage, they must not be used until the damage has been repaired.
• Do not charge near flammable materials or a flammable surface (wooden flooring, carpet, etc.) or conducting surfaces.
• Do not leave your robot unattended while charging.
• Disconnect the USB cable when the robot is finished charging.
• Never charge the device while it is hot.
• Do not cover your robot while it is charging.
• Recharge the battery at a temperature between 0 and 30 degrees C (32 to 90 degrees F).
Copyrights, Registered Trademarks, and Licenses
Copyright © 2014 Wonder Workshop
of this guide in any form or by any process whatsoever is strictly prohibited without prior consent from Wonder Workshop
Wonder Workshop , the Wonder Workshop
TM
Workshop , Inc. All other trademarks mentioned in this guide are the property of their respective owners.
TM
Certain portions of the firmware included or downloaded into the Products contains objects and/or executables derived from
copyrighted sources and licensed under the terms available at
www.makewonder.com/opensource.
Wonder Workshop, Inc. grants you a nonexclusive, nontransferable license to use its proprietary firmware included in the Products
(the "Firmware"), in executable form, solely as embedded in the Products, and solely for your non-commercial use. You may not
copy or modify the Firmware. You acknowledge that the Firmware contains trade secrets of Wonder Workshop, Inc., and, in order
to protect such trade secrets, you agree not to disassemble, decompile or reverse engineer the Firmware nor permit any third
party to do so, except to the extent such restrictions are prohibited by law. Wonder Workshop, Inc. reserves all rights and licenses
in and to the Firmware not expressly granted to you hereunder.
North America Address
Wonder Workshop, Inc.
1500 Fashion Island Blvd. #200
San Mateo, CA 94404 USA
EU Address
Wonder Workshop, Inc. c/o eWarehousing
Nijverheidsweg 27
3274 KJ Heinenoord
Netherlands
Support Contacts
website: help.makewonder.com
email: support@makewonder.com
All manuals and user guides at all-guides.com
, Inc. All Rights Reserved. Patents Pending. The total or partial reproduction or transmission
TM
logo, the Wonder logo and Dash
TM
and Dot are trademarks of Wonder
TM TM
, Inc.
TM