Tools Required; Part Description - Whittier Wood Products 441W Instrucciones Para Armar

441W, 442W & 445W Side Tables
BEFORE BEGINNING ASSEMBLY, check that the quantities of the parts received match those on parts list below.

PART DESCRIPTION

A Long Apron . . . . . . . . . . . . . . . 2 . . . . . . 2
B Short Apron . . . . . . . . . . . . . . 2 . . . . . . 2
C Leg . . . . . . . . . . . . . . . . . . . . . 4 . . . . . . 4
D Shelf . . . . . . . . . . . . . . . . . . . . 1 . . . . . . 1
E Top . . . . . . . . . . . . . . . . . . . . . 1 . . . . . . 1
F #6 x 1/2" Undercut
Type 17 Screw . . . . . . . . . . . 32 . . . . . 36
ASSEMBLY INSTRUCTIONS
WE RECOMMEND FINISHING THE UNIT BEFORE ASSEMBLY.
F
A
E
FIG. 1
1) Lay the Top (E) upside down on a padded surface. Lay each Long Apron (A) in its approximate
location. Insert a Leg Brace (II) into the groove at each end of the long apron. Attach a Leg Brace
to each end of the Long Aprons (A) with a #6 x 1/2" Undercut Type 17 Screw (F). The long flat area
of the brace with two holes must be against the bottom of the Top (E). See FIGURE 1. Now lay the
Short Aprons (B) so that the Leg Braces fit into the grooves in the Short Aprons. Attach the Short
Aprons to the Leg Braces with #6 x 1/2" Undercut Type 17 Screws (F). See FIGURE 2.
Page 2 – 441W, 442W & 445W

TOOLS REQUIRED:

Phillips screwdriver, adjustable wrench.
QTY. QTY.
441W/442W 445W
IMPORTANT:
Before finishing, read enclosed finishing hints.
II
Note: Braces and aprons
must be flush with the
bottom of the table.
PART DESCRIPTION
GG 1/4" x 2¼" Lag Screw . . . . . . . 4 . . . . . . 4
H 90° Bracket (2 hole) . . . . . . . . 0 . . . . . . 2
II Leg Brace . . . . . . . . . . . . . . . . 4 . . . . . . 4
J Washer . . . . . . . . . . . . . . . . . . 4 . . . . . . 4
K 90° Bracket (4 hole) . . . . . . . . 4 . . . . . . 4
Groove is away
FIG. 2
from table top.
QTY. QTY.
441W/442W 445W
B