Whittier Wood Products 441W Instrucciones Para Armar página 3

C
J
FIG. 3
2) Place a Leg (C) top down in one of the corners between the aprons so that the hole that has
been drilled in one corner is facing the Leg Brace (II). Insert the 1/4" x 2¼" Lag Screw (GG) with
Washer (J) through the Leg Brace into the predrilled hole in the Leg and tighten snugly. DO NOT
OVERTIGHTEN OR YOU MAY STRIP THE WOOD. See FIGURE 3. Repeat this procedure for the
other three legs.
FIG. 4
3) Center the apron assembly on the bottom of the Top (E) and fasten the Leg Braces (II) to the Top
with the #6 x 1/2" Undercut Type 17 Screws (F). See FIGURE 4.
FOR 445W ONLY:
Lay a 2 Hole 90° Bracket (H) on the Top (E), centered on the inside edge of each long apron (A).
Fasten to the top and apron with #6 x 1/2" Undercut Type 17 Screws (F). See FIGURE 4A.
II
GG
II
F
H
A
445W ONLY:
FIG. 4A
Leg brace should
NOT bend back to
touch the leg.
FIG. 3A
E
441W, 442W & 445W – Page 3