Battery Removal - BaByliss PRO FX3 Manual De Instrucciones

GOOD
Daily Maintenance:
1. Press the release button on the side of shaver and remove the head
assembly (see Fig. 1 & 2).
2. Use cleaning brush to whisk away any debris on and around cutters (see
Fig. 3).
3. Snap the head assembly closed (see Fig. 4).
Fig. 1 Fig. 2
Weekly Maintenance:
1. Repeat steps 1 – 3 described in Daily Maintenance.
2. Rinse the head of the shaver under running water (see Fig. 5).
NEVER submerge the shaver in water.
3. Leave head open for drying.
4. Press the shaver head back into place
(see Fig. 4 on previous page).

BATTERY REMOVAL

When your rechargeable shaver reaches the end of its useful life, the lithium
ion battery must be removed from the shaver and be recycled or disposed of
properly in accordance with your state and local requirements. If this is not
required by law, you may elect to dispose of the shaver with the battery.
To remove the rechargeable battery:
1. Unplug the shaver.
FXX3S IB-17245.indd 9-10 FXX3S IB-17245.indd 9-10
BAD
Fig. 3 Fig. 4
Fig. 5
Washable
2. Run shaver until motor stops.
3. Remove foil head from shaver (press release button and pull head away from
shaver body).
4. Remove cutters by pulling away from drive shafts.
5. Remove 2 screws from bottom housing. Remove 2 screws from metal plate
under cutters.
6. Lightly pull the bottom housing away from the top housing.
7. Cut battery contact plate from PCB board.
8. Dispose of battery.
CONTAINS LITHIUM ION BATTERY. MUST BE COLLECTED,
RECYCLED OR DISPOSED OF PROPERLY. DO NOT DISPOSE
OF IN THE MUNICIPAL WASTE.
CAUTION: ALL RECHARGEABLE BATTERIES MUST BE RECYCLED OR
DISPOSED OF IN ACCORDANCE WITH APPLICABLE STATE AND LOCAL
REGULATIONS. DO NOT PUT IN FIRE OR MUTILATE, AS THE BATTERY MAY
BURST OR RELEASE TOXIC MATERIALS. DO NOT SHORT-CIRCUIT, AS THIS
MAY CAUSE BURNS.
2021/3/23 9:50 AM 2021/3/23 9:50 AM