Phases; How To Set The Target Humidity Of The Running Cycle; How To Set The Target Temperature Of The Dripping And Running; How To Start The Cycle - Infrico DIXELL XH360L Empleo

a. Push the CLOCK key, the display shows on the bottom display the "dri" message,
while the "hourglass" start flashing,
b. Push again CLOCK the duration of the dipping phase is shown, hh:mm,
c. To set the duration push the UP and DOWN keys,
d. Push again the CLOCK to confirm the time and pass to the setting of the sunning
phase: the "on" message is displayed,
e. Push the CLOCK key to see its duration and use the UP and DOWN keys to set it,
Push again the CLOCK to confirm the time and pass to the setting of the stopping
f.
phase: the "oFF" message is displayed,
g. Push the CLOCK key to see its duration and use the UP and DOWN keys to set it,
h. Confirm the value by pushing again the CLOCK key and pass to the humidity
display.

2.2. HOW TO SET THE TARGET HUMIDITY OF THE RUNNING CYCLE.

a. Push the SET_RH key, the display shows on the bottom display the "SH1" message,
while the "set" icon starts flashing,
b. Push again the SET_RH the humidity set point of the running phase is shown. Set it
using the UP and DOWN keys. To disable the humidity control during the freezing
phase set it to "nu",
c. Push again the SET_RH to confirm the value and pass to the humidity display.

2.3. HOW TO SET THE TARGET TEMPERATURE OF THE DRIPPING AND RUNNING

PHASES

a. Push the SET_T key, the display shows on the upper display the "StG" message,
while the "set" icon starts flashing,
b. Push again the SET_T the temperature set point of the running phase is shown. Set
it using the UP and DOWN keys,
c. Push again the SET_T to confirm the value and pass to the setting of the dripping
phase: the "St1" message is displayed,
d. Push the SET_T key to see its value and use the UP and DOWN keys to set it.

2.4. HOW TO START THE CYCLE

Push and release START key: the led
The led flashes during the proving phase. During dripping periods and repose (off) this
led flashes. And during running phase (to be control temperature and humidity) the led stay on.

2.5. END OF THE CYCLE

Page: 4 /6
will be turned ON.
Date: 06/04/16 Review: 01