Publicidad
Idiomas disponibles
Idiomas disponibles
Before using your new Video Capture system, please read the
following recommendations.
IMPORTANT
•
Do not expose the equipment to extreme weather.
•
Clean only with a soft, dry cloth.
•
1 Video Capture system
•
1 CD drivers
•
1 AC/DC adapter
•
1 USB cable
CONTROLS
Front panel
1.- On/Off button
2.- Snapshop: Press this button and
you can take a picture.
3.- LED indicator on
4.- Motion detector
It´ll flash when detect a motion
Rear panel
5.- USB Port: Here connect the
USB cable and insert it
to a computer´s USB port
6.- CAM1; video input
7.- CAM2; video input
8.- CAM3; video input
9.- DC5V: AC/DC adapter input.
HOW TO INSTALL THE DRIVERS (IN XP)
Do not connect the video capture to computer before driver
installation.
1.- Insert the installation CD, in the screen will appear the wellcome
press the "EyeRealUSB" button
2.- Select "Device driver"
3.- In the next screen press Next to continue
4.- To end, press finish.
5.- Reset the computer.
SOFTWARE INSTALLATION
After installing drivers, please install the Software Application.
1.- Insert again the installation CD, select "EyeRealUSB"
2.- Press the "Aplication software" button, and press the
"EyeRealUSB" button
3.- In the next screen press Next to continue
4.- Select the folder
For select a different folder press the browse button and accept
To continue press the Next button
5.- In the next window select " Yes, I want to restart.."
ENGLISH-01
CONTENT
1
2
3
4
8
9
7
5
6
6.- To end, press Ok and finish.
7.- In the desktop will appear the "EyerealUSB" aplication
CONNECTIONS
After to install the drivers and the software, you can connect the
devices.
1.- Connect up to 3 cameras in CAM1, CAM2 and CAM3 inputs, use
RCA cables. If you have a camera with audio, connect it to "LINE IN"
from the computer
2.- Insert the USB cable from video capture system to an available
USB port from computer.
3.- Connect the AC/DC adapter to DV5V input from video capture
system and extrem connect it to a electrical contact
4.- Turn on the devices.
USB
LINE IN
CAMERA 1
HOW TO USE
After the computer will detect the new hardware
For check, make click in Start/control panel/system/Hardware/devices
administrator.
To appear 3 times "USB 2860 device"
AC/DC ADAPTER
CAMERA 3
CAMERA 2
AUDIO
ENGLISH-02
Publicidad
