Disposal And Recycling; Troubleshooting - Scheppach BC52PB Traducción De Las Instrucciones Originales De Funcionamiento

red hot water boiler, a gas-fi red dryer, etc.
Putting the equipment back into operation
1 Remove the spark plug (see section 10 Change and
clean the spark plug).
2 Quickly tug on the starter cord to remove excess oil
from the combustion chamber.
3 Clean the spark plug and check that the electrode gap
is correct, or insert a new spark plug with the correct
electrode gap.
4 Prepare the equipment for operation.
5 Fill the tank with the relevant mixture of fuel and oil.
See the section „Fuel and oil".
Transport
To transport the machine, empty the petrol tank as
described in section 8 draining fuel. Clean coarse dirt off
the equipment with a brush or hand brush.

12. Disposal and recycling

The equipment is supplied in packaging to prevent it
from being damaged in transit. The raw materials in
this packaging can be reused or recycled. The equip-
ment and its accessories are made of various types of
material, such as metal and plastic. Defective compo-
nents must be disposed of as special waste. Ask your
dealer or your local council.

13. Troubleshooting

The table below contains a list of fault symptoms and explains what you can do to remedy the problem if your equipment
fails to work properly. If the problem still persists after working through the list, please contact your nearest service work-
shop.
Important hint in case of sending the equipment to a service station:
Due to security reasons please see to it that the equipment is sent back free of oil and gas!
Fault Possible cause
The equipment does • Correct starting procedure not followed
not start • Sooted or damp spark plug
• Incorrect carburetor setting
• Blade or nylon cutter mounted incorrectly
• No fuel in the tank
The equipment starts • Incorrect choke lever setting
but does not develop its • Soiled air fi lter
full power • Incorrect carburetor setting
• Cutting blade blunt
The engine does not • Incorrect electrode gap on the spark plug
run smoothly
• Incorrect carburetor setting
Engine smokes • Incorrect fuel mix
excessively • Incorrect carburetor setting
If the temperature of • Engine is overloaded
machines is too high
30 GB
Remedy
• Follow the instructions for starting
• Clean the spark plug or replace it with a new one
• Contact an authorized customer service outlet
• Reassemble the blade or nylon cutter
• Check the fuel level
• Set the choke lever on the
• Clean the air fi lter
• Contact an authorized customer service outlet
• Have cutting blade resharpened /replaced
• Clean the spark plug and adjust the electrode
gap, or fi t a new spark plug
• Contact an authorized customer service outlet
• Use the correct fuel mix (see fuel mixing table)
• Contact an authorized customer service outlet
• Insure the machines have rest at regular time
position