Description And Installation - PNI SafeHouse HS110 Manual De Usuario

EN
Wireless gas sensor PNI SafeHouse HS110 compatible with alarm systems
The wireless gas sensor PNI SafeHouse HS110 is suitable for places where natural gas is being used. It
provides safety gas detection and triggers an alarm in case of gas leakage. The product has the features of
high sensitivity, high stability, multi-type gas detection and small size. This product can be used independent, or
conected wireless to a compatible alarm system like PNI SafeHouse HS550.
Features
When the gas concentration value in surrounding environment reaches 8% LEL, the detector will issue an
alarm sound and transmit wireless alarm signal. When concentration value drops below 4% level in surrounding
environment, the detector will constantly alarm for 1 minute before stopping the alarm, and automatically return
to the normal monitoring status after.
1. SPECIFICATIONS
Power Supply: DC5V (micro USB standard interface)
Working Current: <120uA
Response time: < 30s
Installation type : wall-mounted
Wireless frequency: 433 Mhz

2. DESCRIPTION AND INSTALLATION

USB power
Installation method
Screw Installation is recommended. Adhesive installation is an alternative choice that can be made with caution.
To detach wall support rotate sensor counterclockwise direction. Proceed installation of wall support by screws
. Install sensor back on to the wall support, rotating it clockwise.
To ensure the best viewing angle of LCD display, when installing, use the screws horizontal line as the standard,
place and install the mounting plate horizontally.
Display Information
a. "8%LEL" : Current gas concentration value in the surrounding environment. The higher the value, the higher
the gas concentration value. When the gas concentration value reaches 8% level, An alarm will be triggered.
b. "180" : System preheating countdown time: the detector needs to preheat for 180s after power on. The system
enters normal monitoring status after preheating.
Installation Notice:
a. The product is designed for wall mounted installation. Please install it above the area where the gas leakage
may occur.
b. The detector can not be installed too close to the gas source above, we suggest to install 2 m above the gas
source.( in order to avoid false alarm caused in normal use of gas ).
c. The detector can not be installed in bathrooms or more humid places.
d. The detector is strictly prohibited to get contact with paint and alcohol. If these twoare found in the seme room
with detector, you should isolate them from the detector immediately to prevent damage to the sensor.
3. MUTE, TESTING, PAIRING
Mute: In gas alarm status, press "Test" button on device to mute the alarm.LED light blinking continues.
Testing: In normal status, press the button 'Test' so that the sound and light alarm goes On, and sends
wireless alarm signal.
Pairing: Go to "Add detector" dedicated menu in alarm system, set alarm system into pairing mode, and
Air Inlet
2
Wireless range: ≤ 100m ( open space)
Transmitter power: ≤ 10 dB
Working temperature: 0
Relative humidity: <80% (no freezing)
Test Key
C ~ + 50 C
o o