Uline H-2931 Instrucciones

H-2931, H-5646
π
H-6264, H-7765
4 WHEEL COMBO
KEY CABINET
NOTE: Your 4 wheel changeable combination
is factory set to 0-0-0-0. To unlock this dial,
enter the correct combination and turn knob
clockwise.
CHANGING THE COMBINATION
1. To change the combination, unlock the key cabinet
by dialing the correct combination, and turn the
knob clockwise to unlock.
2. While unlocked, locate the small lever on the
backside of the lock. Push up on lever and
hold while setting the four dials to your new
combination. (See Figure 1) Release the lever and
your combination has now been changed. The old
combination will not work.
Figure 1
NOTE: Keep new combination in a safe place.
WHAT TO DO IF THE COMBINATION IS LOST
1. The four wheel changeable combination comes
with an override key and decoder pin in case the
combination is ever lost. (See Figure 2)
Figure 2
Override Key
PAGE 1 OF 3
1-800-295-5510
uline.com
INSTRUCTIONS
Decoder Pin
2. To use the override key, simply insert it into the
keyway and turn the latch; the cabinet door will
open and the lock may then be decoded.
(See Figure 3)
Figure 3
Override Key
3. To decode the lock, the cabinet door must first be
open. Inside the cabinet door, locate the round
small opening on the underside of the lock housing.
Insert the decoder pin into the opening and spin
each dial in succession starting with the bottom dial.
(See Figure 4)
Figure 4
4. When you have located the correct number on
the dial, the decoder pin will slip upward into
an opening in the dial. The decoder pin will be
fully inserted into the lock body when the correct
numbers on all four dials have been reached. These
four numbers are the lock's combination. You may
then record the combination and keep it in a safe
place or change the combination.
Para Español, vea página 2.
Pour le français, consulter la page 3.
Decoder Pin
0621 IH-2931