First Time Use; Setting The Clock - Micro fridge MFM-7B1 Manual Del Propietário

OPERATING INSTRUCTIONS

FIRST TIME USE

When the appliance is plugged in for the fi rst time,
the display will show "0:00". Use the number pad
to enter the current time and then press the clock
button to confi rm
When setting the cook timer, the appliance will
return to standby mode if there is no input within 60
seconds.
During operation:
• Press the Start/+30SEC button to begin
operation.
• Press the Stop/Cancel button to cancel the
cooking program.
• The appliance will beep fi ve times at the end of
a cooking program.

SETTING THE CLOCK

The clock can be only be set as a 12 hour clock.
To set the current time:
1. Press the Clock button.
2. Use the number pad to enter the current time.
3. Press the Clock button to confi rm.
During operation, press the Clock button to see the
current time.
TIMER
To set the timer function:
1. Press the Timer button.
2. Use the number pad to enter the desired time to
run the timer. The maximum time is 99 minutes
and 99 seconds.
3. Press the Start/+30SEC button to begin timer
operation.
Note: Programs cannot be set while the timer is
running.
TURNTABLE RESET
When a program fi nishes the turntable will rotate
until it returns to the same position it was in when
the program was started so that handles are pointed
toward the door. This means that the turntable may
keep turning after the program is completed to
ensure that the dish is oriented toward the door.
Please do not open the door until the turntable has
completely stopped moving.
Note that this feature will only engage at the end
of a cooking program. If a program is paused
during operation, the turntable reset feature will not
engage.
To disable the turntable reset feature, press and hold
the number 9 on the keypad for 3 seconds. The
display will show "OFF" and the turntable will no
longer reset at the end of a cooking program.
To enable the turntable reset feature, press and hold
the number 9 on the keypad for 3 seconds. The
display will show "On" to confi rm that the turntable
reset feature is active.
9