Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
3. Install hitch: Using flat head screwdriver, remove (1) rubber plug from chassis each side to see access holes. Feed carriage bolts ① and spacers ② through the access hole using
the pull wires ⑤. Leave pull wires attached to hardware and leave hardware inside the frame temporarily. Raise the hitch and feed pull wires previously installed through hitch
bracket slot. Remove pull wires and loosely install conical washers ③ and hex nuts ④ to hitch, see Figure 1.
©2020 Horizon Global™ Corp - Printed in Mexico
Sheet 5 of 18
24996NP
10-02-20
Rev. A
Publicidad
Tabla de contenido
