Electrical Connection; Startup; Symbols Used; Before Using For The First Time - Beem Air Joy Cool Manual De Instrucciones

10 EN
Do not lay tablecloths, cloths or serviettes
‹
under the feet of the appliance, the appliance
could slide away.
The appliance may not be used or stored
‹
outdoors.

Electrical connection

For safe and trouble-free operation of the
appliance, the following instructions on the
electrical connection must be observed:
Before connecting the appliance, com-
‹
pare the connection data (voltage and
frequency) on the rating plate with those of
your mains power supply. This data must
correspond in order to avoid damage to the
appliance. If in doubt, ask your electrical ap-
pliance retailer.
The mains socket must be protected by at
‹
least a 16 A fuse.
Ensure that the mains cable is undam-
‹
aged and is not laid over sharp edges.
The mains cable must not be pulled
‹
tightly, bent or come into contact with hot
surfaces.
Route the mains cable to prevent risk of
‹
tripping.
The electrical safety of the appliance is
‹
only assured when it is connected to a prop-
erly installed protective earth (PE) conductor
system. Connection to a mains socket with-
out PE conductor is forbidden. If in doubt, the
electrical system must be checked by a quali-
fied electrician. The manufacturer assumes
no liability for injury or damage caused by a
missing or interrupted protective earth con-
ductor.

Symbols used

DANGER
This indicates an imminent hazardous situ-
ation, which could lead to severe physical
injury or death.
► Follow these instructions to avoid
danger.
BEEM - Elements of Lifestyle
WARNING
This indicates a possible hazardous situ-
ation, which could lead to severe physical
injury or death.
► Follow these instructions to avoid
danger.
ATTENTION
This indicates a potentially hazardous situ-
ation, which could lead to minor injuries or
material damage.
► Follow these instructions to avoid
danger.
NOTE
► A note contains additional information
to simplify the use of the appliance.

Startup

Unpacking
1. Take the appliance, all accessories and
the user manual out of the box.
2. Remove all packaging materials and pro-
tective foils from the product and the acces-
sories before using for the first time.
3. Check for visible signs of damage or
missing items.
NOTE
► Never remove the rating plate or any
warning signs on the appliance.
► Keep the original packaging during the
warranty or guarantee period in order to
return the appliance in the packaging in
the event of a guarantee claim. Transport
damage will invalidate the warranty or
guarantee.

Before using for the first time

1. Plug the appliance into the mains socket.
2. Insert the batteries (not supplied) into the
remote control according to correct polarity.