ESPRESSO/CAPPUCCINO/
COFFEE MAKER
Read this manual thoroughly before using and
save it for future reference
IMPORTANT SAFEGUARDS
When using electrical appliances, basic safety
precautions should always be followed to
reduce the risk of fire, electric shock, and/or
injury to persons, including the following:
1. Read all instructions before using the
machine.
2. Do not touch hot surfaces. Use handles or
knobs.
3. To protect against electric shock, do not
immerse cord, plugs, or machine in water
or other liquid.
4. Close super vision is necessary when any
appliance is used by or near children.
5. Turn control switch to OFF and unplug
from outlet when not in use and before
cleaning. Allow to cool before putting on or
taking off parts, and before cleaning.
6. Do not operate any appliance with
a damaged cord or plug or after the
appliance malfunctions, or has been
damaged in any manner. Return this
appliance only to the nearest authorized
service center for repair.
7. Do not use outdoors.
8. Do not let cord hang over edge of table or
counter, or touch hot surfaces.
9. Do not place this appliance on or near a
hot gas or electric burner or in a heated
oven.
10. To disconnect, turn any control to "off",
then remove plug from wall outlet.
11. Do not use appliance for other than
intended use.
12. Use on a hard, flat level surface only, to
avoid interruption of air flow underneath
the appliance.
13. Always be sure water tank boiler cap is
tightened securely before turning machine
on.
14. DO NOT remove boiler cap until pressure
is completely relieved. See section
"CAUTION PRESSURE".
15. WARNING: To reduce the risk of fire or
electric shock, do not remove any service
covers. No user serviceable parts inside.
Repair should be done by authorized
personnel only.
16. The use of accessory attachments not
recommended by the appliance
manufacturer may result in lire, electric
shock or injury to persons.
17. When the product is not in use, please
switch the control knob to the position of
"RELEASE OFF".
18. This appliance is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities,
or lack of experience and knowledge,
unless they have been given supervision
or instruction concerning use of the
appliance by a person responsible for their
safety.
19. Children should be supervised to ensure
that they do not play with the appliance.
SAVE THESE INSTRUCTIONS
SPECIAL CORD SET INSTRUCTIONS
a) A short power-supply cord (or detachable
power supply cord) is to be provided to
reduce risks resulting from becoming
entangled in or tripping over a longer cord.
b) Longer detachable power supply cords or
extension cords are available and may be
used if care is exercised in their use.
c) If a long detachable power supply corf or
extension cord is used.
1. The marked electrical rating of the
detachable power–supply cord or
extension cord should be at least as great
as the electrical rating of the appliance.
2. If the appliance is of the grounded type,
the extension cord should be a grounding-
type 3-wire cord, and
3. The longer cord should be arranged so
that it will not drape over the counter top
or table top where it can be pulled on by
children or tripped over.
d) "This appliance has a polarized plug (one
blade is wider than the other). To reduce
the risk of electric shock, this plug is
intended to fit into a polarized outlet only
one way. If the plug does not fit fully into
the outlet, reverse the plug. If it still dose
not fit, contact a qualified electrician. Do
not attempt to modify the plug in any way."
NAME OF PRODUCT COMPONENT
(Product may be subject to change without
prior notice) (Fig. A)
1. Coffee spoon
2. Filter screen
3. Handle of coffee filter
4. Coffeepot
5. Top cover
6. Area for cup warming
2
7. Knob
8. Steam tube
9. Water pan
OPERATING PROCESS
FIRST-TIME USE
1. Take the coffee machine out from the
packing box and check whether the
accessories are complete.
2. Please clean all the removable parts.
3. Please clean it with clean water for 2-3
times according to coffee-making process:
coffee powder is not necessary for
cleaning the coffee machine.
MAKING THE ITALIAN ESPRESSO
COFFEE
1. Please switch the control knob to the
position of "RELEASE OFF" (as shown in
Figure 1).
2. Unscrew the top cover counterclockwise;
use standard coffee pot to add the right
amount of water (as shown in Figure 2):
minimum 2 cups and maximum 4 cups.
3. Screw the top cover of the coffee machine
clockwise (as shown in Figure 3)
4. Use the standard coffee spoon to add the
right amount of coffee powder (as shown in
Figure 4); Use the end of the coffee spoon
handle to even the coffee power out and
compress it tightly (as shown in Figure 5)
5. Please make the coffee funnel upward
aligning with the "Inserting" position of the
coffee machine, and switching it to the
"Locking" position according to „→" (as
shown in Figure 6)
6. Put the standard coffee pot on the water
pan.
7. Switching on the power: switch the control
knob to the position of "
" and the
indicator light is on. After about 3 minutes,
the coffee is flowing out from the funnel.
8. When the coffee reaches the required
amount, please switch the control knob
to the "PAUSE" position and the indicator
light is off. The machine stops working
and the Italian Espresso Coffee making is
completed.
9. Switch the control knob to the position
of "RELEASE OFF" and discharge the
remained pressure.
10. Machine with automamatic power off, In
case the user forgets to pull out the power
plug after coffee making or milk frothing,
the coffee machine will automatically
power off two minutes later. If you want
to make coffee or froth steam again
after automatic power off, you must turn
the function knob to „suspension" or
„decompression" position to reset and
restart using the machine.
WARNING: The coffee machine can not be
kept working continuously. If you need to use it
again, please wait for 3 minutes after releasing
the steam.
MAKING CAPPUCCINO
OR OTHER FANCY COFFEE
1. Cappuccino is made of espresso +
foamed milk So you need to make
espresso at first, and the following content
mainly describes the process of milk
foaming.
2. Switch the control knob to „RELEASE
OFF" position, unscrew the top cover to
add the right amount of water, and screw
the top cover of the coffee machine.
3. Pour the ice milk into the latte cup. Please
use the whole pure milk: cold is better.
Because the milk volume will expand 2-3
times after foaming, so please select the
appropriate container.
4. Switch the control knob to the position of
"
" and the indicator light is on. After 1
minute, the steam tube starts to release
the steam. When the steam comes out,
firstly please spray it to clear away the
remaining hot water inside the tube. After
seeing the water drops coming out from
the tube, switch the knob to the „PAUSE"
position.
5. Immerse the top of the steam tube to 1/3
position of the milk , and switch the control
knob to the position of "
". Gradually
move the top of the steam tube to the
place where is just beneath the milk
surface, but it could be not higher than the
surface. At this time, there will be a fizzy
sound and the milk will be in vortex form
in the latte art cup, which means the air is
getting into the milk.
6. When the milk foam is rich enough, put
the steam tube deep into the milk and
make the milk temperature rise to about
66°C, and then the milk foaming process
is completed. Switch the control knob to
„PAUSE" position and then remove the
latte art cup.
7. Firstly, pour the espresso coffee into the
coffee cup, and then the foamed milk into
the coffee cup. By now the cappuccino
coffee is done. You can also add the right
amount of sugar or cocoa powder on top
according to your taste.
3