Publicidad
TROUBLESHOOTING – SEAL REPLACEMENT.
If valve won't turn on or shut off or refill of cistern water is slow after valve has
been in use for some time, a replacement seal may be needed.
Install as follows:
1. Turn off water, flush
toilet. Unsnap float
rod. Push in on
side and remove
assembly.
18
2. Remove seal, do
not bend stainless
steel stem. Replace
seal, flat side up.
3. Hold hand over
opening, turn water
on and off to clear
debris.
4. Engage lugs, be
sure assembly is
fully turned to stop
and in locked
position. Resnap
float rod. Turn on
water.
Publicidad
