Closemount-Style Fan Mounting - LOWES BDB52ABZC5M Manual Del Usuario

DOWNROD-STYLE FAN MOUNTING
5. If you decided to cut back the lead wires in
Step 4, strip 1/2 in. of insulation from end of
white wire. Twist stripped ends of each strand
of wire within the insulation with pliers (not
included). Repeat Step 5 for black, blue (if
applicable) and green wires.
6.
Install ball end of downrod (A) into opening of
mounting bracket (C). Align slot in ball with tab in
mounting bracket (C).
DANGER: Failure to align slot in ball with tab
may cause the fan to wobble or fall, which could
result in serious injury or death.
Continue to WIRING on page 11.

CLOSEMOUNT-STYLE FAN MOUNTING

1.
Remove canopy cover from bottom of canopy (B).
[NOTE: It may be necessary to use the handle
end of a screwdriver (not included) to remove the
canopy cover by tapping on the canopy cover
from the inside of the canopy (B).]
NOTE: Closemount-style mounting is more
suitable for ceilings lower than 8 ft. high. The
downrod (A), canopy cover, pin and clip are not
used in this type of installation.
5
6
A
1
9
C
Tab
Slot
B
B
Canopy
Cover