HAMPTON BAY 62010 Guía De Uso Y Cuidado

PACKAGE CONTENTS
A
A - Top cover x 10
rechargeable battery (pre-installed)
PLANNING FOR A SUCCESSFUL ASSEMBLY
Read all instructions before assembly and installation.
Inspect each part for defects that may have occurred during shipping.
Keep your receipt and these instructions for proof of purchase.
CHOOSING THE RIGHT LOCATION
Install your solar light in a location with full, direct sunlight. Do not install in shaded areas as these areas will not allow the batteries to fully charge and will reduce
the nighttime operating hours for your light. Ensure that the installation location is away from other nighttime light sources such as street or porch lamps. These light
sources may prevent your solar light from automatically turning on.
HOW SOLAR WORKS
The solar light has a solar panel that converts sunlight into electricity. During the day, the converted electricity is stored in the rechargeable batteries. At night, the
solar light is powered by the batteries using the electricity stored during the day. The operating time depends on geographical location, daily weather conditions, and
season. For optimal performance during the evening, allow the batteries to charge for 6 to 7 hours in direct sunlight.
Assembly and Installation
1
Preparing for installation
□ FOR FIRST TIME USE: Twist
and remove the top cover (A)
from the housing (D). Remove
the pull tab between the top
cover (A) and housing (D).
□ Replace the top cover (A) on the
housing (D).
□ Firmly slide the post (E) into the
solar housing (D).
Use and Care Guide
Solar LED Path Light
B
B - AA 1.2V 500 mAh Ni-Mh
x 10
C
C - Battery cover D - Housing
x 10
2
Install the solar light in the ground
A
NOTE: Do not use a hammer. If the ground is hard, use water to soften or a
trowel to loosen the soil.
D
□
Attach the post (E) to stake (F).
□
Push the assembly firmly into the ground.
A
D
D
E
D
E - Post
x 10 x 10
Please contact 1-855-HD-HAMPTON for further assistance.
Item #1005 698 124
Model #62010
E F
F - Stake
x 10
E
F
HAMPTONBAY.COM