Specific Safety Instructions; Machine Information - VONROC ET503DC Traducción Del Manual Original

power tool is maintained.
b) Never service damaged battery packs. Service
of battery packs should only be performed by the
manufacturer or authorized service providers.

SPECIFIC SAFETY INSTRUCTIONS

• Always assume that the tool contains fasteners.
Careless handling of the tacker can result in un-
ex pected firing of fasteners and personal injury.
• Do not point the tool towards yourself or anyone
nearby. Unexpected triggering could discharge
the fastener causing an injury.
• Do not actuate the tool unless the tool is placed
firmly against the workpiece. If the tool is not in
contact with the workpiece, the fastener may
be deflected away from your target.
• Disconnect the tool from the power source
when the fastener jams in the tool. While
removing a jammed fastener, the tacker may be
accidentally activated if it is plugged in.
• Use caution while removing a jammed fastener.
The mechanism may be under compression and
the fastener may be forcefully discharged while
attempting to free a jammed condition.
• Do not use this tacker for fastening electrical
cables. It is not designed for electric cable
installation and may damage the insulation of
electric cables thereby causing electric shock
or fire hazards.
Before using the tacker
Check the following points:
• Always wear eye protection when using the tool.
• Maintain the tool with care.
• Check for misalignment or binding of moving
parts, breakage of parts, and any other con-
dition that may affect the tools operation. If
damaged, have the tool serviced before using.
• Check if the slide cartridge has been fastened
properly.
• Do not use the tool in a humid environment.
• Do not use the tool on materials containing
asbestos.
• Secure the workpiece firmly. Use clamps or a
vice to firmly hold the workpiece. This results in
a safer grip than with your hand.
• Always ensure that the cable is behind the device.
WWW.VONROC.COM
Using the tool
• Do not use the tool if the switch does not move
in "0" or "I" position.
• Always hold the tool with two hands while starting.
• Always keep the cord away from the moving
parts of the machine.
• Keep your hands away from the work piece.
• In the case of jamming by a nail or staple,
switch the machine immediately in lock position
and remove the plug from the mains.
• Never aim the tool at people or animals.
• Use only staples or nails fit for this tool.
• Make sure not to damage any leads when using
the tool.
FOR THE CHARGER
Intended use
This tacker has an integrated lithium-ion battery,
which you can charge with the included USB
charging cable (USB-mains adapter not included).
a) The appliance is not to be used by persons
(including children) with reduced physical,
sensory or mental capabilities, or lack of
experience and knowledge, unless they have
been given supervision or instruction.
b) Children being supervised not to play with the
appliance.
c) Do not recharge non-rechargeable batteries!
d) During charging, batteries must be placed in a
well ventilated area!
e) Integrated batteries may only be removed
for disposal by qualified personnel. Opening
the housing shell can destroy the power tool.
To remove the battery from the power tool,
press the On/Off switch (4) until the battery is
fully discharged. Unscrew the screws on the
housing and remove the housing shell in order
to remove the battery. To prevent a short circuit,
disconnect the connectors on the battery one
at a time and then isolate the poles. Even when
fully discharged, the battery still contains a
residual capacity, which can be released in case
of a short circuit.

2. MACHINE INFORMATION

Intended use
The tacker enables you to fasten various materi-
als, such as fabric, wood, gauze, cardboard and
leather. Therefore, the tool is suitable to upholster
furniture, to wrap objects or to repair shoes.
EN
7