VONROC ET503DC Traducción Del Manual Original página 9

Before loading the tacker, make sure the
machine is in "0" position.
Never load staples and nail at the same time.
Checking the cartridge shaft
The cartridge filling level window (7) indicates the
amount of staples/nails inside the cartridge shaft.
Using the tacker
After every load test the machine on a piece
of scrape.
• Press the "0/I" switch (4) to "I" to unlock the
machine.
• Press the "0/I" switch (4) to "0" to lock the
machine.
NOTE: When not in use, press the "0/I" switch to
"0" to lock the machine.
NOTE: Always store in Lock on "0" position.
Placing the tool
1. Place the tool on workpiece at the spot where
the staple or nail should be located.
2. Press the tool down firmly by pressing the ma-
chine on the top (5) with one hand.
3. Use your other hand to operate the switch (3).
4. By pressing the machine down firmly you lift the
safety of the machine.
Warning! The safety of the machine will be
lifted when pressure is applied to the safety
pin (6) on the bottom of the machine.
Always make sure the tacker mouth is in
direct contact with the material when
pressing the switch.
Stapling
• Press the switch (3).
The tool will cause a re bound because of
the impact it operates with. Keep this in
mind. For long nails and staples this can
cause wrong stapling or nailing. When
backpressure is applied wrong stapling or
nailing can be avoided.
WWW.VONROC.COM
4. MAINTENANCE
Make sure that the machine is not live when
carrying out maintenance work on the motor.
This machine has been designed to operate over a
long period of time with a minimum of maintenance.
Continuous satisfactory operation depends upon
proper machine care and regular cleaning.
Malfunction
Should the machine fail to function correctly, a
number of possible causes and the appropriate
solutions are given below:
In case a staple or nail is jammed in the tool, follow
the procedure below:
• Place the machine in "0" position (4).
• Open the cartridge shaft (2) by pulling the reload
lever (1) and let the jammed nails/staples fall out.
• Reload the machine, see chapter " Loading the
nails or staples" for instructions.
• Test the machine on a piece of scrap.
Cleaning
Regularly clean the device's casing with a soft
cloth, preferably after each use. Keep the fan slits
free of dust and dirt. Remove tough dirt using a
soft cloth, dampened with soapy water. Do not use
solvents such as benzene, alcohol, ammonia, etc.,
which might damage the plastic parts.
ENVIRONMENT
Faulty and/or discarded electrical or
electronic apparatus have to be collected at
the appropriate recycling locations.
Only for EC countries
Do not dispose of power tools into domestic waste.
According to the European Guideline 2012/19/
EC for Waste Electrical and Electronic Equipment
and its implementation into national right, power
tools that are no longer usable must be collected
separately and disposed of in an environmentally
friendly way.
EN
9