AVS Ventvisor Instrucciones De Instalación

For proper installation and best possible fit, please read all instructions BEFORE you begin.
For technical assistance or to obtain missing parts, please call Customer Service at 800-241-7219
Important Safety Information
• CAUTION - Before driving, ensure that the vent visors are properly secured to vehicle.
• Do not use automatic "brush-style" car washes.
• Do not use cleaning solvents of any kind.
• Periodically check all components for tightness.
• When using Surface Prep, avoid contact with skin. Use in well ventilated area. If contact is made with
material, flush area with large amounts of water. If irritation persists, get immediate medical
attention. USE PREP ON RUBBER ONLY
Contents
NOTE: Actual product may vary from illustration.
Front Driver
Visor
Tools Required
Preparation Before Painting / Installation
• Please review your warranty card BEFORE installation of this product.
• A trial fit is recommended to ensure proper positioning and fit.
• Check fit of parts before painting as we will not accept the return of modified or painted parts.
• Wash and dry your vehicle to remove any debris and/or dirt from the installation area.
Installation Steps
Remove the plastic window guide from the channel by
releasing the spring clip (store for future use if the visors
are ever removed). Replace channel into window frame.
window guide
1
Installation Instructions
Ventvisor
Front Passenger
Visor
Car Wash Supplies
NOTE: Actual application may vary slightly from illustrations.
driver side visor
Deflector
®
Alcohol Pad x2
Clean Towel Nut driver
Remove triangular plastic mirror cover on the
inside door panel of vehicle. Loosen, but do
not remove the indicated nut, to create the
necessary gap behind the mirror cap to install
loosen nut
2
Page 1 of 3
I - Sheet Number VV24 Rev.A
Surface Prep
Scotch Brite pad
Pad
the front flange of visor.
mirror cap
inside door panel