Shinco SDO-10D Manual Del Usuario página 7

Empty the water tank
1
Carefully pull out the water
tank 6 to avoid spilling water.
Caution! If water appears to be in-
side the appliance, empty the wa-
ter tank and let the appliance dry.
Remove intake grille
1
For cleaning the intake grille 9
(see "Care and Maintenance"),
push the two flaps holding it
and remove it.
Open the air outlet grille
1
When putting the appliance
into operation, open the flap
of the air outlet grille 2 by
pushing it open at the mark la-
belled with PUSH.
Switch on
1
Insert the power supply cord
7 into a suitable wall socket.
Press the on/ off button E.
Caution! Do not plug the appliance
into a multiple socket with other
devices.
Use the condensation drain
1
Condensation water can per-
manently be derived with a
drainage hose.
2
Empty and reinstall the water
tank 6. Make sure it is installed
properly.
Install intake grille
2
Push the intake grille 9 gently
onto the housing until it clicks
into place.
Close the air outlet grille
2
Close the air outlet grille 2 by
pushing down the flap.
Switch off
2
Press the on/ off button E to
switch off the appliance.
Note: Wait 3 minutes until
switching on the appliance
again.
2
Make sure that the hose is at-
tached firmly and ensure an
unhindered water drain.
EN 5