Max Min Mode - Uline H-7095 Manual Del Usuario

RELATIVE MODE
This function applies only to voltage, current,
temperature and capacitance modes. In relative
mode, a reference reading can be stored with which to
compare subsequent readings. Press the REL button to
store the displayed reading in memory; this becomes
the reference. The symbol will be displayed when
the relative mode is active. Subsequent readings will
now be compared to the stored reference (displayed
reading is measurement minus reference). Press the
REL button again to exit the relative mode; the relative
symbol will switch off.
BATTERY AND FUSE REPLACEMENT
WARNING! To avoid electrical shock, remove
the test leads, disconnect the meter from any
circuit and turn OFF the meter before opening the
case. Do not operate with an open case.
BATTERY REPLACEMENT
1. Remove test leads from meter. (See Figure 9)
2. Remove the meter's protective cover (2).
3. Remove the Phillips head screw (3) that secures the
battery compartment at the back of the meter (5).
4. Open the battery compartment and replace the
two AA batteries (4), observing correct polarity.
Reassemble the meter before use.
CAUTION! Dispose of batteries responsibly.
Never dispose of batteries in a fire, batteries
may explode or leak. If the meter is not to
be used for 60 days or more, remove the
batteries and store separately.
FUSE REPLACEMENT
The 600mA fuse can be replaced from the battery
compartment. (600mA/600V 6.3 x 32 mm ceramic fast blow)
1. To replace the 10A fuse, remove the four screws
that secure the meter housing. Remove the small
Phillips screw in the battery compartment.
2. Replace the fuse with one of the same type and
rating. Reassemble the meter before use. (10A/600V
6.35 x 32 mm ceramic fast blow)
PAGE 10 OF 39
OPERATION CONTINUED

MAX MIN MODE

Press the MAX MIN button to start recording the max
and min measured values. The max icon will appear on
the display. Press the MAX MIN button to step through
and view the max value, the min value and the max
min value. Press and hold the MAX MIN button for two
seconds to exit the mode. Max min is available for
voltage, current, resistance and temperature. Manual
range is automatically selected in this mode.
MAINTENANCE
CLEANUP AND STORAGE
Periodically wipe the case with a damp cloth and mild
detergent; do not use abrasives or solvents.
Figure 9
3
CAUTION! Never dispose of used batteries or
rechargeable batteries in household waste. As
consumers, users are legally required to take
used batteries to appropriate collection
sites, the retail store where the batteries were
purchased or wherever batteries are sold.
2
4
5
0621 IH-7095