Care And Cleaning - AVS Ventvisor Deflector Instrucciones De Instalación

Installation Steps
6 Piece Set
Remove tape liner from Extended Rear Visor.
free end
10
Gently press the exposed areas of tape against the surface and
verify position. With the visor in its final position, remove the re-
maining tape liner by pulling on free ends.
12
Repeat Steps 1 - 13 for opposite side.

Care and Cleaning

• Wash only with mild soap & dry with a clean cloth.
Congratulations!
You have purchased one of the many quality Auto Ventshade™ branded products offered by Lund International, Inc. We take the utmost pride in our
products and want you to enjoy years of satisfaction from your investment. We have made every effort to ensure that your product is top quality in
terms of fit, durability, finish and ease of installation.
™ Auto Ventshade
NOTE: Actual application may vary slightly from illustrations.
top flange
front flange
Lund International, Ventshade Accessories Division
655 Raco Drive, Lawrenceville, GA 30045
800-241-7219 • Fax 770-339-5839 • Visit us at lundinternational.com
© 2008 Lund International, Inc. All rights reserved.
, the Auto Ventshade logo, and the AVS
TM TM
Align the deflector on the outside of the door frame. Align the front of
the Extended Rear Visor parallel to the previously installed Rear Visor.
align
11
Apply pressure along all flanges to ensure proper adhesion of tape.
13
logo are trademarks of Lund International, Inc.
TM
Page 3 of 3