Ac Measurements; Specifications; Replacing The Battery - USAG 075 P Manual De Instruccion

Alternating current measurements (AC)
• Position the deviator (6) on the A AC function
• Connect the output cord to the instrument selected for the measurement,
according to the polarity of the signal
• Wind only one conductor and close the jaw
• Read on the instrument's display the value of the current being measured
Note: the digit "1" on the display means that the value being measured exceeds
the selected capacity.
N.B.: during the current measurements, the instrument with respect
to ground shall not be set to voltages above 1000V.

SPECIFICATIONS

Ampere DC
Range
1000A
Outlet ratio:
Protection:
Ampere AC
Range
1000A
Outlet ratio:
Protection:
Working frequency: 50 - 60 Hz
Replacing the battery (1 battery, 9V, 6F22)
Warning: before opening the instrument to replace the battery:
• disconnect the clamp meter from the current cable being checked, disconnect
the pins from the connected instrument.
• The battery shall be replaced when the signal LED/instrument ON during the
measurement becomes less bright.
Outlet
1000mV
1A DC / 1mV DC
1200A for 60 seconds max
Outlet
1000mV
1A AC/1mV DC
1200A for 60 seconds max
Accuracy
±3% ±5 digit
Accuracy
±3% ±5 digit
9
I
GB
F
D
E
P