Spare Blades - Romus TERA Manual Del Usuario

MAINTENANCE
Unplug the machine after each use.
Check the sharpness and the condition of
the blade's tungsten carbide teeth. Clean the
inside of the machine and remove any
shavings which may have become trapped.
Changing the blade
Unplug the machine before performing any
blade-changing operation.
Unscrew the 3 blade cover screws.
Using the wrench provided, remove the
blade screw.

SPARE BLADES

For safety PVC flooring:
Ref. 95017 diamond blade for ∅ 4
-
mm welding rod.
ROMUS GUARANTEE
The machine is delivered to the user under the
conditions applying at the time of purchase. The
user must not modify the machine for any reason
whatsoever. In case of faults, users must contact
their nearest after sales service provider. Any
attempt by the user or any unauthorised person
to modify a component of the machine will render
the guarantee void and relieve ROMUS of all
liability for injury or damage to people or property
resulting from
cannot therefore be held liable in the following
cases:
7
such modifications. ROMUS
GB – « TERA » grooving machine
Blade screw
Blade spindle
Remove the blade pin from the blade
Clean the inside of the machine before fitting
the new blade. Replace the blade and its
spindle.
CAUTION: turn the spindle until it clicks
to ensure that it is fully engaged.
Then refit and tighten the blade screw.
Caution: check the blade
direction (anti-clockwise,
as per markings on the
blade
Blade spindle
For homogeneous
homogeneous PVC,
and, linoleum:
- Ref. 95009 tungsten carbide 12-tooth
blade for ∅ 4 - 5 mm welding rod.
- Faulty installation;
- Incorrect use
individuals not having received the
appropriate training ;
- Use not in compliance with the standards
applying in the country of use;
- Non-performance or poor performance of
required maintenance;
- Use of non-original or incorrect spare
parts for the model;
- Failure to follow the instructions in part or
in their entirety.
).
PVC, non-
sports floors
of the machine by