MTD Rear Tine CRT Tiller 400 Manual Del Operador página 13

Ocultar thumbs Ver también para Rear Tine CRT Tiller 400:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Clearing the Tines
The tines have a self-clearing action which eliminates most
of the tangling of debris. However, occasionally dry grass,
stringy stalks or tough vines may become tangled. Follow
these procedures to help avoid tangling and to clear the
tines, if necessary.
To reduce tangling, set the depth regulator deep enough
to get maximum "chopping" action as the tines chop the
material against the ground. Also, try to till under crop
residues or cover crops while they are green, moist and
tender.
While tilling, try swaying the handlebars from side to side
(about 6" to 12"). This "fishtailing" action often clears the
tines of debris.
WARNING!
Before clearing the tines by hand, stop
the engine, allow all moving parts to stop and
disconnect the spark plug wire. Failure to follow this
warning could result in personal injury.
Tilling Tips & Techniques
Tilling Depth
WARNING!
Before tilling, contact your telephone
or utilities company and inquire if underground
equipment or lines are used on your property. Do
not till near buried electric cables, telephone lines,
pipes or hoses.
This is a CRT (counter-rotating tine) tiller. As the wheels
pull forward, the tines rotate backward. This creates an
"uppercut" tine action which digs deeply, uprooting soil
and weeds. Don't overload the engine, but dig as deeply
as possible on each pass. On later passes, the wheels may
tend to spin in the soft dirt. Help them along by lifting up
slightly on the handlebar (one hand, palm up, works most
easily).
Avoid the temptation to push down on the handlebars in
an attempt to force the tiller to dig deeper. Doing so takes
the weight off the powered wheels, causing them to lose
traction. Without the wheels to hold the tiller back, the
tines will attempt to propel the tiller backward, towards the
operator.
When cultivating (breaking up the surface soil around the
plants to destroy weeds, see Fig. 5-3), adjust the tines to
dig only 1" to 2" deep. Using the shallow tilling depth helps
prevent injury to the plants whose roots often grow close
to the surface. If needed, lift up on the handlebars slightly
to prevent the tines from digging too deeply. (Cultivating
on a regular basis not only eliminates weeds, it also loosens
and aerates the soil for better moisture absorption and
faster plant growth.) Watering the garden area a few days
prior to tilling will make tilling easier, as will letting the
newly worked soil set for a day or two before making a
final, deep tilling pass.
Figure 5-3
Choosing Correct Wheel & Tine Speeds
With experience, you will find the tilling depth and tilling speed
combination that is best for your garden. Set the engine throttle
lever at a speed to give the engine adequate power and yet
allow it to operate at the slowest possible speed until you have
achieved the maximum tilling depth you desire. Faster engine
speeds may be desirable when making final passes through the
seedbed or when cultivating. Selection of the correct engine
speed, in relation to the tilling depth, will ensure a sufficient
power level to do the job without causing the engine to labor.
s
5 — O
ectiOn
peratiOn
13

Publicidad

Capítulos

Tabla de contenido

Solución de problemas

loading

Tabla de contenido