Proper Use; Technical Specifications; Scope Of Delivery - Würth ANALOG 60 Traducción Del Manual De Instrucciones De Servicio Original

Components
Overview (fig. I)
1 Power supply unit
2 Power cord
3 Power cord to soldering iron
4 Potential equalization jack
5 Calibration potentiometer
6 Power switch
7 Viscose sponge
8 Sponge container
9 Soldering tip
10 Soldering iron
11 Holder
12 Funnel holder
13 Operation mode indicator
14 Temperature scale
15 Rotary knob
16 Fuse / fuse switch
17 Power cord

Technical specifications

Item
Power supply unit
Performance
Primary voltage
Secondary voltage
Version
Fuse
Soldering iron with soldering tip
Performance
Voltage
Heating-up time
Weight without cords
12
0715 94 50
60 W
220 V, 50/60 Hz
24 V
Protective insulation
315 mAT
60 W / (350 °C)
24 V
Approx. 60 s
approx. 60 g

Proper use

The device is designed for the intended use only,
i.e. it must only be connected and operated as
described in the operating instruction. The device is
designed for soldering using genuine Würth system
accessories.
Any other use is considered improper use.
The user is liable for damage resulting
from improper use.

Scope of delivery

Upon receipt, check that the delivery is complete
and in good order.
The device consists of:
Power supply unit
■
Power cord
■
Soldering iron with soldering tip
■
Holder with viscose sponge
■
Operating instructions
■
Start up [fig. I]
Make sure that the operating voltage conforms with
the data specified on the type plate.
Set the power switch [6] to 0.
■
Plug the power cord [17] into the rear of the
■
device. Plug the power cord into the socket.
Connect the soldering iron [10] with the power
■
supply unit and place it in the holder.
Note
Do not hit the soldering iron against
hard surfaces, since the ceramic heat-
ing element is fragile.
Moisten the sponge [7] well and place it in the
■
holder [8].
Switch on the device.
■
Set the required temperature using the rotary
■
knob [15].
If fixed temperatures are required: see "Setting
■
fixed temperatures".