Broan 678 Manual De Instrucciones página 2

INSTALL THE HOUSING
New Construction
1. Slide adjustable mounting
brackets into channels on
sides of housing.
2. Choose the location for
your fan/light in the ceiling.
For best possible perfor-
mance, use the shortest
possible duct run and a
minimum number of el-
bows.
3. Position mounting brackets against joist. Mark the keyhole
slot on both mounting brackets.
4. Set housing aside and drive nails partially into joist at the
top of both keyhole marks.
5. Hang housing from nails and pound nails tight. To ensure
a noise-free mount, crimp the bracket channels tightly
around the mounting brackets.
INSTALL THE HOUSING
(continued)
Position bottom
edge of brackets
slightly above
6. To adjust vertical housing position: Loosen adjustment
bottom edge
of joists.
1. Choose the location for your fan/light in the ceiling. For best
2. In attic, position housing
4. Place housing in opening. Position mounting brackets
MODELS 678 • 679 • 680 • 679FL • 680FL
New Construction
ADJUSTMENT SCREWS
screws on both sides of housing. Move housing up or down
until adjustment screws line up with mark indicating your
finished ceiling thickness. Tighten screws securely.
Existing Construction
possible performance, use the shortest possible duct run
and a minimum number of elbows.
in desired location. Trace
outline of housing on ceiling
material.
Position bottom
edge of brackets
slightly above
bottom edge
of joists.
against joist and nail to joist through keyhole on both sides.
To ensure a noise-free mount, crimp the bracket channels
tightly around the mounting brackets.
Page 2
1-1/4 1-1/4
1
1
3/4 3/4
1/2 1/2
3. Set housing aside
and cut ceiling open-
ing slightly larger
than marked.