Technical Specifications; General Warnings; Installation Warnings - Perry 1PARXGPS01 Manual De Instrucciones

ENGLISH
PE - DERXNN007 07/10

2 - GENERAL WARNINGS

Important: installation and electrical connections of
devices and appliances must be carried out by skilled
people and in compliance with current regulations. The
manufacturer declines any liability in connection with the
use of products subject to special environmental and/or
installation standards.
• Read this manual carefully before using the product because
it contains important indications regarding safety, installation
and use. Keep this manual available for further consultation.
The manufacturer has the faculty to introduce all the technical
and production changes which will be deemed necessary
with no obligation of prior notice.
• Ensure the product is intact once it is removed from its packaging.
• Before installing or opening the device again, always disconnect the supply voltage 230V~
DISPOSAL OF OLD ELECTRICAL & ELECTRONIC EQUIPMENT (EU directive 2002/96/EC)
This symbol on the product or its packaging to indicates that this product shall not be treated as household waste.
Instead, it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment, such as for example:
- sales points, in case you buy a new and similar product
- local collection points (waste collection centre, local recycling center, etc...).
By ensuring this product is disposed of correctly, you will help prevent potential negative consequence for the environment and human health, which
could otherwise be caused by inappropriate waste handing of this product.
The recycling of materials will help to conserve natural resources. For more detailed information about recycling of this product, please contact your
local city office, your house hold waste disposal service or the shop where you purchased the product.
Attention: in some countries of the European Union, the product is not included in the field of application of the National Law that applies the European
Directive 2002/96/EC and therefore these countries have no obligation to carry out a separate collection at the "end of life" of the product.

3 - INSTALLATION WARNINGS

“
The receiver must be installed in areas sufficiently covered by the GPS signal
“
Install the product outdoors or near a window and avoid installation in cellars or shielded rooms.
“
Install the product as far as possible from metal objects such as cabinets, electrical panels, fixtures, beams, metal
windows, electrical cables etc. and away from devices that emit electromagnetic radiation such as televisions,
monitors, electric motors, generators etc.
Note: in particular weather conditions such as overcast skies, rain etc. GPS reception may not be optimal.
GPS SATELLITE TIME SIGNAL RECEIVER
FOR SYNCHRONIZABLE TIME SWITCHES

1 - TECHNICAL SPECIFICATIONS

Supply voltage:
Device Type:
Precision:
Absorption:
GPS receiver sensitivity:
Integrated antenna gain:
Type of output:
Cross-section of wires to terminals:
Max devices connected:
Max length of output line wires:
Insulation class:
Protection degree:
Installation:
Operating temperature:
Storing temperature:
Reference standard for CE mark:
230V~ +/- 15% 50 ÷ 60 Hz
electronic
Based on GPS atomic clock
9 mA @ 230VAC max
-159 dBm
> 2 dBi
Logic signal (bus)
0,5 ÷ 2,5 mm²
no. 10
1,000 m
Class II
IP65
outdoor
-20 °C ÷ to 40 °C
-40 °C ÷ to 85 °C
directive R&TTE1999/5/CE
Overall dimensions
72
Æ 4.2
Æ 10
6
37.5
22
fig. 1
(US Department of Defense)
Components of the device
Protective
cover and
electronic
circuit
Leds
Terminals
Faston
Seal
Base
Fairlead
Grommets
Cable gland
fig. 2
3