Lista CSB-20 Manual De Instrucciones página 35

Always work in the direction going away from
people and solid objects such as walls, large
stones, trees, vehicles etc.
If the blade stalls, immediately stop the Hedge
trimmer. Remove the battery pack and clear the
jammed debris from the cutting blade.
Wear gloves when trimming thorny or prickly
growth.
Move the Hedge trimmer to feed the branches
directly into the blade cutting edges.
Do not try to cut stems that are too large to feed
into the cutting blade.
TOP CUTTING (SEE FIG. E)
Use a wide sweeping motion. A slight downward
tilt of the cutting blades in the direction of motion
gives the best cutting results.
E
SIDE CUTTING (SEE FIG. F)
When trimming the sides of the hedge, begin at
the bottom and cut upwards, tapering the hedge
inward at the top. This shape will expose more of
the hedge, resulting in a more uniformed growth.
WARNING: Check extension cords before
each use. If damaged replace immediately.
Never use your tool with a damaged cord
since touching the damaged area could cause
electrical shock resulting in serious injury.
If the supply cord is damaged, it should be
replaced by a local approved Service Centre.
F
MAINTENANCE AND
STORE
WARNING: Remove the battery before
carrying out any adjustment, servicing
or maintenance.
1) Never use water to cleaning the unit.
2) Always clean the hedge trimmer immediately
after use. Brush the blade using a stiff nylon
brush to remove any debris.
3) Always store the unit in a dry place.
4) Inspect the hedge trimmer before each use.
5) Have the unit professionally repaired if any
damage occurs.
6) The blade rail should be cleaned and treated
with fine oil after each use.
7) Use the blade sheath for transportation and
storage.
TROUBLESHOOTING
Although your new cordless hedge trimmer is
really easy to operate. If you do experience
problems, check the following:
1. If trimmer will not operate
• Check battery pack assembly
• Charge the battery: Operation of the hedge
trimmer is dependent upon sufficient charge
in the battery pack.
Note: The battery pack will only fit into the
charger with + to + and - to -. The charger will not
operate at extremes of temperature.
The charger will get warm during charging but
this is normal.
2. If the battery will not charge
Check to see if the battery is properly inserted
into the charger base, and make sure the
indicator light is on, if not check the plug and fuse
connected with supply.
3. If the trimmer is not cutting properly
Check the condition of the blades, if the blade
is blunt or damaged have them repaired by a
qualified service agent.
4. If a fault is suspected return the trimmer to
an authorized dealer for repair.
Note: There are no user serviceable parts in the
trimmer.
If a fault is suspected return the trimmer to an
authorized dealer for repair.
35