Allmand PAL50 Dual Manual Del Operador página 7

NOTICE
We encourage the use of authorized Allmand
parts. The warranty does not cover damage or performance
problems caused by the use of parts that are not authorized
replacement parts.
1. Make sure that a copy of the Operator's Manual is with
the unit.
2. Make sure that you can read all the safety decals, and
that they are in their correct locations on the unit. See
Safety Decals in the Safety section of this manual.
3. Make sure that the unit operates correctly. (See
Operating The Unit for detailed information on operating
procedures.)
• Make sure that the inner mast can be raised and
lowered properly with the winch.
• Make sure that the LED fixture hardware is tightened.
• Make sure that the power cord, base cables and
fixture cables are not frayed or damaged, and that the
connectors are not damaged.
• Make sure that the mast socket knob and light bar
knob are tightened.
• Make sure that the wheels are in good condition, and
that they roll freely.
4. Plug the power cord into a wall or generator outlet.
See Specifications for detailed information on power
requirements.
5. Turn the power switches to the ON position to make sure
that the LED fixtures operate. See Troubleshooting if
the LED fixtures do not come on. When finished, turn the
power switches to the OFF position and disconnect the
power cord from the outlet.
Work Site Considerations
Prior to setting up and operating the work light, the operator
must determine where to place it on the work site. It is the
operator's responsibility to ensure that the work light is
properly and safely positioned on at the work site. Be sure to
follow rules or instructions for your work site, and any state,
province and federal rules that may apply.
®
replacement
Overhead Obstructions
Always keep well clear of any overhead power wires. Make
sure there are no overhead obstructions where you intend to
place the portable work light. Keep clear of any loose cables,
ropes or obstructions that could ensnare the mast or LED
fixtures. When the mast is fully elevated, the portable work
light stands 138 inches (350.5 cm) from ground level to the
top of the LED fixtures.
DANGER
Electrocution Hazard.
Contact with overhead electrical wires will result in death
or serious injury. Always follow the rules or instructions for
your work site, and the state, province and federal rules for
maintaining a safe distance from overhead wires.
Wetness & Wind
The portable work light must be placed on a dry surface away
from areas that might become wet.
WARNING
Shock Hazard.
Positioning a portable work light on a wet surface or in
water will result in death or serious injury. Always position
the work light on a dry surface away from areas where
water may flow or accumulate.
Do not set up the work light in an area where winds exceed
10 mph (16 km/h).
WARNING
Unsafe Operation Hazard.
Operating the portable work light with the mast fully
elevated in winds exceeding 10 mph (16 km/h) can cause
work light tip over resulting in death or serious injury.
Always fully lower the mast when winds are expected to
exceed 10 mph (16 km/h).
7