Using Your Electronic Control; Display Icons - Lynx LM15ICER Manual De Instrucciones

USING YOUR ELECTRONIC CONTROL

On/off

Display icons:

"ON/OFF" icon : used for turning the appli-
ance on and off.
"MENU" icon : used to access optional func-
tions in the user interface.
"Clock" icon : used to enter the Delay start/
vacation mode.
"LOCK" icon : used to lock out functions in
the user interface.
Display area text:
Signifies the appliance is on and producing
ICE
ice.
Signifies the appliance is in economical ice
ECO
production mode.
Signifies the appliance is off
OFF
Signifies a door ajar alarm condition.
DOOR
Cleaning is recommended or the appliance
CLEAN
is in the clean mode.
14
CARE AND USE/INSTALLATION
Menu Display area
ICE
ECO
1 4 6 8
hours
days
OFF CLEAN
Figure 23
User interface display
DOOR
Delay start/Vacation mode:
hours
1
days
Hours or days timer is set for
Hours or days will be lit
When lit, this signifies the delay start/vacation mode
is operational.
NOTE
The control display is covered with a clear plastic protective
film. This film may be removed by carefully lifting at a
corner.
Starting your clear ice machine:
Plug the ice machine into a 115 volt wall outlet,
(see page 5 for electrical information). Your
appliance is shipped from the factory in the "ICE" mode
and will begin start-up of ice production after the start-up
routine.
Upon applying power to the unit, or after a power
interruption, the Ice machine will perform a self-test,
followed by a harvest cycle to clear any in-process ice
production. This start-up routine, ("after power is applied
to the unit"), takes approximately 13 minutes to complete
before an ice production cycle starts.
If the appliance does not start, confirm the wall outlet has
power, and the control is in the "ICE" mode, (see Options
section below). Do not start the ice machine in "ECO"
mode. "ECO" mode should only be used after there is a full
bin of ice.
Delay timer Lock
4
6
8
ICE