Error Codes; Options Menu; Normal And Eco Mode - Lynx LM15ICER Manual De Instrucciones

USING YOUR ELECTRONIC CONTROL

Error codes:

The ice machine is monitored continuously. Any OPEN or
SHORTED circuit condition with a temperature sensor or
miscommunications between the control and user interface
will initiate an ERROR CODE as listed below:
Error
"OFF" will flash continuously in 1
Bin Sensor error second intervals in the display. No
audible alarm will sound.
"ICE" will flash continuously in
System Sensor error the display. No audible alarm will
Continual flashing of all indicators
Communication error

Options menu:

Normal and ECO mode:

Your ice machine comes with an optional "ECO" mode.
This new feature allows you to tailor ice production to a
conservative rate, saving approximately 25% energy and
30% water from routine operation. While in this mode
ice production will slow and the appliance will use less
water and electricity. "ECO" mode should only be initiated
after there is a full bin of ice. To enter "ECO" mode do the
following:
• Press the "MENU" icon twice and the green
"ECO" will flash.
• Press and hold the "ON/OFF" icon until the
green "ECO" stops flashing and remains
illuminated.
• To return to the standard operating rate press the
"MENU" icon twice, the ECO will turn off and the
"ICE" will be flashing. Press and hold the "ON/
OFF" icon until the "ICE" stops flashing and
remains illuminated.
16
CARE AND USE/INSTALLATION
Displayed Code
Failed temperature sensor. Machine operation will imme-
Failed condenser temperature sensor. Machine opera-
tion will continue but ice production cycle will not adapt to
sound.
Loss of communication between the main board and the
on the display.
Error Codes
Error Description
diately enter an OFF state.
varying ambient conditions, so ice quality may vary.
user interface.
ECO
ICE
Action to Take
Call service to have the
temperature sensor replaced.
Call service to have the
temperature sensor replaced.
Call service to have a
diagnostic check.