Lynx LM15ICER Manual De Instrucciones página 18

CLEANING YOUR ICE MACHINE
Figure 26
Remove all of
the ice from
the ice bin
Figure 28
18
CARE AND USE/INSTALLATION
Lift fascia door up to
access evaporator plate
Figure 27
Remove the
black reservoir
drain plug from
the bottom of
the reservoir.
Figure 28b
Refer to your cleaning solution instructions to determine
the proper amount of cleaning solution to add based on
2 quarts (1.9 liters) of water. Lift fascia door up to access
evaporator plate (See Figure 29). Pour the cleaning
solution slowly on the evaporator plate so it flows down into
the fresh water reservoir. (See Figure 30).
Splash shield
brackets
Replace the splash shield if removed.
Turn the ice machine back on by pressing and
holding the "ON/OFF" icon for 3 seconds. The
display will indicate "ICE" mode. Press and hold the
"MENU" icon until a flashing "CLEAN" is dis-
played. Press the "ON/OFF" icon until "CLEAN"
stops flashing. Your ice machine will now enter
the clean cycle.
The clean and rinse cycle will take about 49 min-
utes.
After the clean cycle is complete the ice machine
will return to the "OFF" position.
After the cleaning cycle is completed, verify that all build-up
has been removed. If not repeat the clean cycle procedure.
Evaporator
plate
Figure 30
Grid cutter
Splash shield
Figure 29
Pour cleaning solution slowly
onto the front edge of evaporator
plate behind the grid cutter.
ICE
CLEAN
OFF