Installation - Glacier bay 815N-0001 Guía De Instalación Y Cuidado

Installation

1
Installing the connector
CAUTION: Always turn off the water supply before
removing an existing faucet or replacing any part of a
faucet. Open the faucet handle to relieve water pressure
and ensure that the water is completely shut off.
□
Shut off the water supply. Remove the old
faucet.
□
Clean the mounting surface.
□
Wrap thread sealant tape (not included) around
the stub out pipe (1) threads extending from the
wall in a counterclockwise direction, as shown.
□
Place the ange (D) onto the connector (E) and
wrench-tighten the connector (E) onto the stub
out pipes (1) extending from the wall (do not
over tighten).
D
E
3
Installing the soap dish
(optional)
□
Hand-tighten the soap dish support rod (B) into
the top of the nut at the back of the faucet
body (A).
□
Place the soap dish (C) on the threaded end of
the rod with the edge of the soap dish (C) parallel
to the wall.
2
□
A
1
4
Installing the faucet assembly
Insert the washers (F) into the faucet body (A),
and then wrench-tighten the faucet body (A) to
the connectors (E).
E
F
B
C
A