Operation; Care And Cleaning; Troubleshooting - Glacier bay 815N-0001 Guía De Instalación Y Cuidado

Operation

1
Flushing and checking for leaks
IMPORTANT: After installation is complete, remove the
aerator from the faucet (A) to ush the water lines. Do not
lose the gasket (1) in the aerator.
□
Ensure the faucet (A) handles are in the off
position, and turn on the water supply and check
for leaks. If you discover any leaks, check your
connections to ensure they are installed properly.
□
Remove the aerator and housing (if applicable).
Turn on the hot and cold handles to allow the
water to run for at least one minute. This
ushes away any debris that could cause
damage to internal parts.
□
Turn off the water and reinstall the aerator and
housing (if applicable).

Care and Cleaning

□
To clean, wipe down with a damp cloth and dry with a towel.
□
Do not use abrasive cleaners, steel wool, or harsh chemicals when cleaning this faucet, or the warranty will
be voided.

Troubleshooting

NOTE: Refer to the service parts section in this manual for
a detailed drawing showing the location of the parts listed
below.
Problem
The aerator has an
irregular or reduced
water ow.
The water will not shut off
completely.
Possible Cause
The aerator is dirty or mis- tted.
The cartridge is dirty or broken.
A
□
□
□
□
5
Please contact 1-855-HD-GLACIER for further assistance.
1
Solution
Remove the aerator and
check for debris.
Ensure that the rubber washer
is properly installed.
Remove the handle to check
the cartridge.
Clean or replace.
HOMEDEPOT.COM/GLACIERBAY