Flymo Micro Lite Instrucciones Originales página 7

Ocultar thumbs Ver también para Micro Lite:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 31
WARNING. When using the machine the safety rules must be followed. For your own safety and
that of bystanders please read these instructions before operating the machine. Please keep the
instructions safe for later use.
Explanation of Symbols on your product
Warning
Read the user instructions carefully to
make sure you understand all the controls
and what they do.
Keep bystanders away. Do not operate
whilst people especially children or pets
are in the area.
General
1. This product is not intended for use by persons
(including children) with reduced physical, sensory
or mental capabilities, or lack of experience and
knowledge, unless they have been given
supervision or instruction concerning the use of
the product by a person responsible for their
safety. Children should be supervised to ensure
that they do not play with the product. Local
regulations may restrict the age of the operator.
2. Never allow children or people unfamiliar with the
instructions to use the machine.
3. Stop using the machine while people, especially
children, or pets are nearby.
4. Only use the product in the manner and for the
functions described in these instructions.
5. Never operate the product when you are tired, ill or
under the influence of alcohol, drugs or medicine.
6. The operator or user is responsible for accidents
or hazards occurring to other people or their
property.
Electrical
1. The use of a Residual Current Device (R.C.D.) with a
tripping current of not more than 30mA is
recommended. Even with a R.C.D. installed 100%
safety cannot be guaranteed and safe working
practice must be followed at all times. Check your
R.C.D. every time you use it.
2. Before use, examine cable for damage, replace it
if there are signs of damage or ageing.
3. Do not use the product if the electric cables are
damaged or worn.
4. Immediately disconnect from the mains electricity
supply if the cable is cut, or the insulation is
damaged. Do not touch the electric cable until the
electrical supply has been disconnected. Do not
repair a cut or damaged cable. Replace it with a
new one.
5. Your extension cable must be uncoiled or
unwound, coiled or wound cables can overheat
and reduce the efficiency of your mower.
6. Keep cable away from product, always work away
from the power point using up and down, never in
circles.
7. Keep the cable clear of the cutting area and
obstacles at all times.
8. Do not pull cable around sharp objects.
9. Always switch off at the mains before
disconnecting any plug, cable connector or
extension cable.
Safety
The use of eye protection is
recommended to protect against objects
thrown by the cutting parts.
Do not operate in the rain or leave the
product outdoors while it is raining.
Switch off! Remove plug from mains before
adjusting, cleaning or if cable is entangled
or damaged.
the plastic cutters.
10. Switch off, remove plug from mains and examine
electric supply cable for damage or ageing before
winding cable for storage. Do not repair a
damaged cable, replace it with a new one. Use
only Flymo replacement cable.
11. Always wind cable carefully, avoiding kinking.
12. Never carry the product by the cable.
13. Never pull on the cable to disconnect any of the plugs.
14. Use only on AC mains supply voltage shown on
the product rating label.
15. Our products are double insulated to EN60335.
Under no circumstance should an earth be
connected to any part of the product.
Cables
Use only 1.00mm
2
size cable up to 40 metres length
maximum.
Maximum rating:
1.00mm
2
size cable 10 amps 250 volts AC
1. Mains cables and extensions are available from your
local Husqvarna UK Ltd. Approved Service Centre.
2. Only use extension cables specifically designed
for outdoor use.
Preparation
1. While using your product always wear substantial
footwear and long trousers.
Make sure the lawn is clear of sticks, stones,
2.
bones, wire and debris; they could be thrown by
the plastic cutters.
3. Before using the machine and after any impact,
check for signs of wear or damage and repair as
necessary.
4. Replace worn or damaged plastic cutters together
with their fixings in sets to preserve balance.
Use
Use the product only in daylight or good artificial
1.
light.
Avoid operating your product in wet grass, where
2.
feasible.
3. Take care in wet grass, you may lose your footing.
4. On slopes, be extra careful of your footing and
wear non-slip footwear.
5. Use across the face of slopes, never up and down.
6. Exercise extreme caution when changing direc-
tion on slopes.
7. Using on banks and slopes can be dangerous.
Do not use on banks or steep slopes.
8. Do not walk backwards whilst operating your
product, you could trip. Walk never run.
ENGLISH - 1
Keep the cable away from

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Micro lite mlite28Micro lite mlite30

Tabla de contenido