Nozzle Maintenance - The Fountainhead Group 190511 Manual De Uso Y Cuidado

Changing Nozzles
This sprayer comes with a brass adjustable cone nozzle installed. It may be replaced by one of the sup-
plied fan tips, using the supplied cap nut.
1. Remove brass adjustable cone nozzle from sprayer by turning the plastic nozzle body counter-clock-
wise (Figure G).
2. Insert desired nozzle tip into the cap nut (Figure H).
3. Install nozzle tip by turning cap nut clockwise onto the nozzle base (Figure I).
4. Check and adjust the orientation of the fan tip before finally tightening the cap nut.
5. Pressurize the tank as described in the Pressurizing section, before safely using the sprayer as de-
scribed in the Spraying section.
Figure G

Nozzle Maintenance

1. If nozzle clogs, remove and disassemble the nozzle assembly.
2. Clean the openings of any obstructions and reassemble.
Finish
1. Depressurize the tank as described in Release Tank Pressure section.
2. Turn the pump counterclockwise to remove the pump.
3. Empty any remaining liquid according to the product disposal directions.
4. Follow the Cleaning instructions.
Cleaning
1. Remove the pump as described in the Finish section.
2. Fill the tank with cool, clean tap water. Replace the pump and tighten securely.
3. Agitate the tank to rinse the chemical from the tank wall and pump.
4. Remove the pump and empty the contents into gravel or bare soil.
5. Refill the tank with cool, clean tap water.
6. Make sure the pump is free of dirt or debris and reinstall into the tank. Tighten
securely.
7. Pressurize the tank as described in the Pressurizing section.
8. Direct the nozzle away from you and activate the trigger for at least 30 seconds to
clean the sprayer.
9. Release pressure as described in the Release Tank Pressure section.
10. Remove the pump and empty the contents into gravel or bare soil.
11. Repeat steps 5 - 10 until thoroughly cleaned.
Sprayer Storage
1. Sprayer tank should be stored upside down, with the pump removed.
2. Do not store or leave any solution in the tank after use.
3. Store in a warm, dry location out of direct sunlight.
4. Keep the sprayer and all chemicals out of the reach of children.
OPERATING INSTRUCTIONS CONTINUED
Figure H Figure I
Page 5