Tabla de contenido
Publicidad
ENGLISH
PSU product manual
Power supply installation (For new system assembly)
Power supply installation (For replacement)
After turning off the system, switch the
power supply to "O" position to disable
system standby and make sure the system
is no longer drawing any power.
Remove AC power cable from the
power supply.
3
Turn on the power supply by switching to "I" (I/O) mode.
Caution: The power supply is on standby now. System
on and off is controlled by the motherboard.
(Please refer to the motherboard manual)
13
1
Remove all power supply cables
connected to the motherboard, video
card, hard drive and other device.
2
Remove power supply from the chassis.
(Please refer to your chassis's installation manual.)
5. Please refer now to Step 1 of "Power supply
installation (for new system assembly)"
3
4
Publicidad
Tabla de contenido
