Publicidad
Enlaces rápidos
Flex ATX SERIES
SST-FX500-G
The reference Flex ATX power supply
Support standard Flex ATX form factor
High efficiency with 80 PLUS Gold certification
500W continuous power output at 40℃ operating temperature rated for 24/7 operation
Class-leading single +12V rail
PCIe 8pin and PCIe 6pin connectors support
±3% regulation and low ripple & noise performance for high stability.
Active PFC
Publicidad
Manuales relacionados para SilverStone Flex ATX Serie
Resumen de contenidos para SilverStone Flex ATX Serie
- Página 1 Flex ATX SERIES SST-FX500-G The reference Flex ATX power supply Support standard Flex ATX form factor High efficiency with 80 PLUS Gold certification 500W continuous power output at 40℃ operating temperature rated for 24/7 operation Class-leading single +12V rail PCIe 8pin and PCIe 6pin connectors support ±3% regulation and low ripple &...
- Página 2 SPECIFICATION Flex ATX Form Factor SST-FX500-G 500W Switching Power Supply With Active PFC 80Plus Gold 1.0 INPUT: 1.1 VOLTAGE MINIMUM NOMINAL MAXIMUM UNITS 100~240 Vrms 1.2 FREQUENCY 47Hz ~ 63Hz 1.3 CURRENT 100~240V / 6A 1.4 INRUSH CURRENT No damage...
- Página 3 1.5 POWER EFFICIENCY MEET 80 Plus Gold at 115Vac input. LOAD 3.3V +12V -12V +5VSB SPEC 1.65A 2.0A 6.87 A 0.05A 0.41A 4.12A 5.0A 17.19A 0.12A 1.03A 100% 8.24A 10.01A 34.37A 0.25A 2.06A In order to meet Eup* requirements the following quidance must be met for the 5Vsb efficiency at 230V AC.
- Página 4 ＊ The continuous total output power is 500W max. • The combined power of +5V and +3.3V is 90W max. ＊ Add 0.1uF and 10uF capacitors across output terminal during ripple & noise test. ＊ LOAD REGULATION TEST TABLE: +3.3V +12V -12V...
- Página 5 2.6 TURN-ON DELAY TIME 2000 msec max.At nominal line full load. 2.7 TRANSIENT OVERSHOOT +/-10% max with 30% load change(+12V 40% load chang) on all outputs are 100% of the rated. Load slew rated 1A/uS and capacitive load as below : + 3.3V +12V -12V...
- Página 6 3.0 PROTECTION When OPP, OVP,OTP or short protection is triggered, the main outputs will be latched off. The main outputs can be reset by cycling the DC remote on/off or AC power. +5Vsb output is auto recovery when fault condition removed. 3.1 OVER POWER PROTECTION Foldback at 115%~150% over peak load 3.2 OVER VOLTAGE PROTECTION...
- Página 7 A single PCIe 8pin cable and connector’s maximum current rating Die maximale Stromstärke eines einzelnen 8-poligen is 12.5A, which is 150W (+12V x 12.5A). So SilverStone’s PCIe-Kabels und Anschlusses beträgt 12,5 A, was 150 W (+12 V warranty will not cover damages or malfunction resulting from the x 12,5 A) entspricht.
- Página 8 Le courant nominal maximum d'un câble et d'un connecteur PCIe 8 estos límites. La garantía de SilverStone no cubrirá daños o fallos a broches unique est de 12,5 A, ce qui correspond à 150 W (+12 V x resultas de un uso excesivo de estos conectores y sus cables 12,5 A).
- Página 9 大4pin（molex）或SATA接头的最大额定电流为5A，即60W（+ 12V x ที ่ เ ชื ่ อ มต่ อ กั บ เมนบอร์ ด สามารถทำงานภายใต้ ข ี ด จำกั ด เหล่ า นี ้ ไ ด้ การรั บ ประกั น ของ SilverStone ไม่ ค ุ ้ ม ครองความเสี ย หาย...
- Página 10 1. 為了保護使用者及防火的目的，安裝此交換式電源供應器時，必須安裝於符合下列各項要求的外殼中， 並且安裝妥善後，才可接上電源。 1-1. 外殼材質須為防火外殼。外壳材质须为防火外壳。 1-2. 外殼的上方及側邊之圓形開孔，最大內徑不可大於5mm。 1-3. 外殼的上方及側邊之長條型開孔，對角線距離不可大於5mm；若寬度小於1mm，則長度不受限制。 1-4. 外殼底部不可有開孔。外壳底部不可有开孔。 直徑不大於5mm Openings that do not exceed 5mm in any dimension 對角線不大於5mm 寬度小於1mm 則長度不限 Openings that do not exceed 1mm in width regardless of length 2. 本產品輸出含有危險能量，為避免操作時發生危險，須於裝入系統機殼並將所有設備安裝妥當後才可開啟電源。 3. 本產品之電源輸出非屬電力限制型電源，請連接使用具防火外殼之周邊，以避免火災危險發生。 BSMI ROHS 資訊 http://www.silverstonetek.com/downloads/PSU/RSD.pdf...
- Página 11 Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. ※付属の電源コードは当該製品専用です。他の機器に使用しないでください。 Please refer to SilverStone website for latest specifications updates.
- Página 12 G11239991...