Smanos DS-20 Manual Del Usuario página 4

EN
Installation
There are aligning marks
on the sides of the
transmitter and magnet;
make sure the marks face
each other and within the
range of 1 cm (0.4").
K1 Hub will sound 3 beeps to confirm that the sensor is placed
within range of the hub prior to installation.
Now you can install your sensor by using the supplied double-sided
tapes.
Place the sensor near the location
that you would like to monitor.
Set the K1 system to Test Mode and
then separate the magnet from the
transmitter
Specifications
Model: DS-20
Power: 3V CR123A Li-Mn battery x 1 pc
Radio frequency: 868MHz or 915MHz (±75KHz)
Operating conditions:
0-50°C/32° - 122°F, humidity < 90% RH (non-condensing)
Transmitter dimensions (L x W x H):
23.8 x 26.4 x 70mm/0.94" x 1.04" x 2.76"
Magnet dimensions (L x W x H):
14.9 x 10.4 x 70mm/0.59" x 0.41" x 2.76"
EN