Hunter HERITAGE Manual Del Propietário página 5

opEratIoN
this appliance is for household use
only.
1. Place the fan on a dry, safe, flat
surface where it cannot fall or
be pulled by the cord.
2. plug the fan into a grounded
120-volt aC electrical outlet (or-
dinary household current).
Do Not use any other type
of outlet. make sure that the
rated voltage of the fan is the
same as the power source be-
fore plugging it into the power
source.
Handle
HERITAGE mODEL
44800-01 11/29/2007
Oscillation
Pin
Power / Speed
Control Switch
fIGUrE 3
3. turn the fan "oN" or "off"
by sliding the power/Speed
Control to the up or down. the
power should always be off
before unplugging the fan.
4. to select the speed, move the
power/Speed Control up from
off (o) to the desired speed
setting: Low, medium. or High.
5. to make the fan oscillate, push
the oscillation pin down. to stop
oscillating, pull the oscillation
pin up.
Handle
RETRO mODEL
Oscillation
Pin
Power / Speed
Control Switch
5