Initial Configuration Of The Hand Held Controller - RV Products AIRXCEL Coleman-Mach 47000 Serie Instrucciones Operativas Y De Mantenimiento

Battery Indicator (only visible
when battery is low)
POWER
Turns Unit On or Off
MODE
Scroll to Select
System Operating Functions
FOLLOW ME
Turns Follow Me Mode
On and OFF
V. Initial Configuration of the Remote Controller
The controller has been factory configured to operate the heat pump. Should you wish to verify the correct
configuration, the controller must be in either the Heat ELE or the Auto-changeover (Auto) mode.
A. Heat ELE mode.
1. Press the Power Button.
2. Using the Mode button, scroll through the various setting by repeatedly pressing the Mode
button until Heat ELE is shown.
3. Press the MODE & FAN Buttons for 5 seconds. The temperatures on the screen will disappear
and HP should appear at the bottom of the screen. If nHP is shown, press the UP & DOWN
buttons to select HP.
4. After 5 seconds, the remote will revert to normal operation.
B. Auto-changeover Mode
1. Press the Power Button.
2. Using the Mode button, scroll through the various setting by repeatedly pressing the Mode
button until Auto is shown.
3. Press the MODE & FAN Buttons for 5 seconds. The temperatures on the screen will disappear
and HP, nHP or Gas should appear at the bottom of the screen. If nHP or Gas is shown, press
the UP & DOWN buttons to select HP.
4. After 5 seconds, the remote will revert to normal operation.
-4-
UP DOWN UP DOWN
Adjust various set points Adjust various set points
including Temperature and including Temperature and
Time Time
FAN
Scroll to Select Fan Speed
F/C
Select either Fahrenheit or Celsius