Selecting The Manual Mode Of Operation - RV Products AIRXCEL Coleman-Mach 47000 Serie Instrucciones Operativas Y De Mantenimiento

VI.

Selecting the Manual Mode of Operation

The air conditioner (if equipped with heat) or heat pump has five modes of operation- Cooling, Heating,
Auto (Auto-changeover), Dry and Fan. To select the desired operation, press the MODE button. Then use
the UP or DOWN button to select the set point temperature. Select the desired fan speed by pressing the
FAN button. To advance to the next mode, press the MODE button.
Cooling: The unit will operate in cooling mode to maintain the set point temperature.
In the Cooling Mode, four fan selections are available: High speed continuous, Low speed continuous, Auto
High or Auto Low. In Auto, the Fan cycles on & off with the compressor. Use the Fan button to select the
desired setting. To advance to the Heating mode, press the MODE button.
Heating: The unit will operate in heating mode to maintain the set point temperature. There are two
selections in the Heating Mode – Heat Pump (ELE) and GAS (gas furnace).
(Heating only functions on air conditioners with electric heat, heat pumps or vehicles with an auxiliary
source of heat, e.g. a gas furnace.)
A. Vehicles without a gas furnace
1. Using the Mode button, scroll through the various setting by repeatedly pressing the Mode
button until HEAT ELE is shown.
2. Using the UP & DOWN buttons, select the desired set point temperature.
3. Press the FAN button to select either High or Low Fan speed.
4. Press the mode button twice to go to Auto Mode, bypassing the HEAT GAS set up.
B. Vehicles with a gas furnace
1. Repeat steps 1-3 above.
2. Press the MODE button once and Heat GAS is shown.
3. Using the UP & DOWN buttons, select the desired set point temperature.
4. In HEAT GAS, the fan speed is selected automatically; the user can not select the fan speed.
5. Press the MODE button to go to AUTO mode.
NOTE: HEAT GAS should only be used if a gas furnace is to be operated with the controller. In
Gas heat mode, Follow Me is automatically turned on. See description of Follow Me below.
Typical Cooling Screen
-5-