Operation; Initial Setup; Replacing All Tip Cartridges; Mx-Ptz And Talon Operation - OK International Metcal MX-5000 Serie Guia Del Usuario

7.

OPERATION

a. INITIAL SETUP
1. Connect hand-piece(s) to power unit output connector(s).
2. Insert your selected cartridge into the hand-piece.
3. Push the cartridge all the way until it seats.
•
4. Place hand-piece(s) into associated workstand(s).
5. Add distilled water to workstand sponge (sulfur free) if equipped.
6. Plug the power cord into a grounded wall socket of the rated input line
voltage.
7. To turn the unit "ON", push the power switch. NOTE: Unit must be
grounded, otherwise it will not work. Unit will not work in an electrical
network where an isolation transformer has been used.
8. Select the desired output using the output selector/command button. The
active output will display an animated box cursor ( ) to the left or right of
the screen, respectively, to indicate the active output.
b. REPLACING ALL TIP CARTRIDGES
1. Make sure the system is turned off.
2. Pull out the cartridge using the Cartridge Removal Pad (MX-CP1). NOTE:
THE TIP CARTRIDGE MAY BE HOT. DO NOT USE METAL TOOLS
(PLIERS, ETC) TO REMOVE CARTRIDGES!
3. Push a new cartridge into the handle.
4. Place hand-piece(s) into associated work stand(s).
5. Push the power switch "ON". The new cartridge will heat up to temperature
quickly.
c. MX-PTZ AND TALON OPERATION
1. Clean, and then tin tips well once heated.
2. Ensure tips contact all leads on device, either
the bevel or straight portion of the tip can be
used. Use solder across the leads to create a
Thermal Bridge.
3. Squeeze tool. Wait for all leads to reflow.
4. Maintaining pressure, lift component.
d. MX-PTZ TIP ALIGNMENT
e. USER PROGRAMMABLE POWERSAVE MODE ADJUSTMENT
1. With the system in the Ready or Power Modes, press and hold the Output
Selector/Command Button for 3 seconds until the time flashes.
2. Release the Output Selector/Command Button.
3. Press the Output Selector/Command Button until the desired time is
achieved. The time will increment by 10 minutes with each press of the
button.
4. Press and hold the Output Selector/Command button for 3 seconds to
return to operation.
For TATC cartridges, align the flat side of the cartridge shaft with the
opening in the handle. Push in the cartridge until it seats. The
cartridge is fully seated when the insertion mark is flush with the
handle. Do not push past this mark. Repeat for second cartridge.
10
Thermal Bridge