Initial Use; Before Use; Fitting The Universal Stirrer - Parkside PFMR 1600 B2 Instrucciones De Utilización Y De Seguridad

˜ Initial use
˜ Unpacking
m
WARNING!
The product and the packaging are not
u
children's toys! Children must not play with
plastic bags, sheets and small parts! There
is a danger of choking and suffocation!
1 . Unpack all parts and lay them on a flat,
stable surface .
2 . Remove all packing materials and shipping
devices if applicable .
3 . Make sure the delivery contents are
complete and free of any damage . If you
find that parts are missing or show damage
do not use the product but contact your
dealer .
Do not use the product unless missing parts
have been delivered in addition or defective
parts have been replaced . Using an
incomplete or damaged product represents a
hazard to people and property .
4 . Ensure that you have all the accessories and
tools needed for assembly and operation .
This also includes suitable personal
protective equipment .
˜ Accessories
To operate this product safely and correctly, the
following accessories, i . e . tools and attachments,
are necessary:
Suitable personal protective equipment
¾
28 GB/IE
Accessories and tools are available through
your authorised dealer . When buying always
consider the technical requirements of this product
(see "Technical data") .
If you are not certain, ask a qualified specialist
and get advice from your trusted dealer .
˜ Before use
m
WARNING!
Risk of accident if the machine is operated
u
using electrical power supply that does
not match the specifications shown on the
rating label of the tool .
The mains voltage and the frequency of
u
the power source must correspond with
the specifications on the machine's rating
plate .
m
WARNING!
Always switch the product off and
disconnect it from the mains before
performing inspections, installing
accessories or making adjustments!
˜ Fitting the universal stirrer
Screw the shaft 4b into the spiral 4a
¾
completely (Fig . B) .
Then screw the assembled universal stirrer
¾
4 into the agitator shaft 3 completely
(Fig . C) .
Tighten the universal stirrer 4 firmly by
¾
using assembly spanners 2 per rotational
direction (Fig . D) .