Tuner Operation; Usb Operation; Program Mode - Ltc Audio CDM100-BL Manual Del Usuario

TUNER OPERATION

1. Press SOURCE button on remote control to select TUNER MODE.
2. Tune to the desired radio station by using / CH+ , / CH-, / FF, / FF+ for manual tuning.
3. For AUTO TUNING, press button on the unit or SEARCH button on remote control to enter in automatic searching
radio station mode.
For a best FM reception
• Make sure that you have fully extended the FM antenna wire.
Preset Radio Stations:
You can store up to 40 of your favorite stations in the tuner memory for easy recall at any time.
1) Press SOURCE button on remote to select TUNER, and press GOTO button, the VFD will display
"_ _ _: _ _" digital input mode, please input FM frequency of the radio station that what you want to listen.
For example: 106.20, after input station frequency by using the number buttons, press PLAY button to confirm.
2) Once the desired radio station is tuned, press MEMORY button on remote control, VFD will display " CH_ _" ; input
the preset number you want to store the radio station.
How to recall presets radio stations
Press GOTO button on remote control, VFD will display " CH_ _", and press the preset number of the radio station to
recall it. For example, press 1 to play the radio station you preset in position 1.
If the preset number is above 10, press '+10 ' button on remote control and number key to input second digit preset
number.
The unit can be used to play the music from many types of external device
1. Connect by using a 3.5mm Male-to-Male Stereo cable the external device to the LINE IN connector/jack of the
unit.
>If your TV has only one output for audio (MONO). Connect it to the left (white) audio jack on the unit.
2. Press SOURCE repeatedly to select the LINE IN MODE.
3. Start playback on the external audio device. Adjust the volume on the audio device (do not set the volume to a
high level in order to avoid distortion). You may also adjust the volume on the appliance.
To control playback function, use the controls on the external audio device.

USB OPERATION

You can enjoy media files saved on an USB device by connecting the USB device to the USB port of the unit.
Connect the USB device to the USB port of the unit.
1.
Select the USB MODE by pressing CD/USB on your remote control
2.
Select a file you want to play using /CH+, /CH-,/FF, / FF+ directly thanks to number keys.
3.
Press  on remote control or on the unit to start the playback.
4.
Turn the VOLUME knob or press VOL+ / VOL-to increase or decrease volume level.
5.
Press  stop button on unit or on remote control to stop USB playback.
6.
Before disconnecting the USB device, change the source by pressing SOURCE button.
7.
Compatible USB Device:
Mp3 player: Flash type Mp3 player.
USB Flash Drive: Devices that support USB2.0 or USB 1.1. The USB function may not be available depending on
device.
Device which require additional program installation when you have connected it to a computer, are not supported.
Do not unplug the USB device while in operation.
For a large USB capacity, it may take longer than a few minute to be searched. To prevent data loss, back up all data.
If you use a USB extension cable or USB hub, the USB device is not recognized. Using NTFS file system is not
supported. (Only FAT (16/32) file system is supported) This unit is not supported when the total number of files is
1000 or more. External HDD, locked devices or hard type USB devices are not supported.

PROGRAM MODE

The operation of PROGRAM MODE are as the same as that of CD / MP3. Please refer to CD / MP3 OPERATION
section paragraphe PROGRAM.